CaliDragon 150%
Рет қаралды 815
29 күн бұрынChube doobie dooooo
Calidragon, 150%.
0.4 nozzle, 0.2 layer height, .5 line width, 600mms commanded (SCV intense print/many corners), 40SCV, 50K acceleration, ABS, 290C.
Chube hot end, 120W heater. Can't print at these temps with this much fan or thermal trips. But a blanket over and no issues.
@CaZa3D 27 күн бұрын
Still the king.
@MrRocksalt 25 күн бұрын
So kind, but plenty faster machines out there!
@joe_duck 27 күн бұрын
That is a good design you made. That sock is insane, did you mold one?
@MrRocksalt 27 күн бұрын
That is some silicone sleeve w/glass fiber insulation. Get the right I.D. and it slip fits right over.
@barrazao12 27 күн бұрын
Amazing work here! So far, how would you compare the Chube to the Goliath hotend?
@MrRocksalt 26 күн бұрын
Chube is more robust, more copper, heavier, parts can be changed out and more towards an industrial hotend. Goliath is lighter and less mass to heat. This means Goliath can heat faster the heat zone, but it can be cooled faster as well with filament and part cooling. Thermistor placement is not right with Goliath and the heating coil does not extend down low enough IMO. If printing at sane speeds for the plastic, Chube will win that battle for it's robustness and longevity.
@barrazao12 26 күн бұрын
@@MrRocksalt thanks for the response, cant wait to see more videos of your amazing machine!
SatisFactory Process
Рет қаралды 435 М.