Man.. this is one badass caddy. Love the way it sounds with that lopey idle just so sweet sounding. Im with you on the type of spoiler for the caddy. It aint a full on race car and wicker bills look outta place. This is much sleeker and goes with the flow of the lines of the car. Nothing obstrusive sticking out at a sharp angle messing it up.
@whiplashtv202221 күн бұрын
Thank you!
@96darkhorse1 Жыл бұрын
Looks good man! I’ve been eyeing this wicker bill-less spoiler but never seen it installed. This was exactly needed to see lol
@whiplashtv2022 Жыл бұрын
Thanks! I am glad that the video helped you. I think it fits the car and it’s design perfectly.
@kuurizzo1896 Жыл бұрын
Looks good man
@whiplashtv2022 Жыл бұрын
Thanks you!
@LatheWerks6 ай бұрын
Great explanation. Good technique, hopefully the red ribbon doesn't snap as you pull it
@whiplashtv20226 ай бұрын
Thanks
@michaelnguyen9700 Жыл бұрын
added that plus maybe the cf hood !
@whiplashtv2022 Жыл бұрын
You should!
@BESTONYOUTUBE8989 ай бұрын
Looks good
@whiplashtv20229 ай бұрын
Thanks
@JackJohnson-le3xc2 ай бұрын
I recently installed the same one and after looking at it the next day, the sides started to come off so I had to put weight to keep it stuck on. Do you think the tape is bad and won’t stick now?
@whiplashtv20222 ай бұрын
I added extra tape to mine. My car is ceramic coated, and I actually some lift up as well but it hasn’t tried to come off at all. I could see where adding some weight initially during installation could be helpful.
@JackJohnson-le3xc2 ай бұрын
Ok thanks for the help, I’m gonna leave some weight on for a few days and hopefully that should do the trick. Glad I wasn’t the only one.
@whiplashtv20222 ай бұрын
@JackJohnson-le3xc 👍🏻👍🏻
@whothehellischance8 ай бұрын
are you on coil overs or lowering springs?
@whiplashtv20228 ай бұрын
No, I’m on stock suspension
@whothehellischance8 ай бұрын
Wow the fitment looks really good. What’re the wheels specs? Using any spacers?
@whiplashtv20228 ай бұрын
@whothehellischance no spacers 19x8.5/19x9.5 both on a 35mm offset
@blairalderton2238 Жыл бұрын
Looks good, but whoa, your V sounds NASTY! Have you made any 1/4 mile laps? Curios what it ET's.
@whiplashtv2022 Жыл бұрын
Thank you very much! On stock bottom end and stock converter it went 10.3 @ 136mph and the video of that pass is here on the channel. It is now a high compression 416 stroker with a 4600-4800 RCR Spec Circle D converter. I have not been to the track yet sonce then. There is videos on the 416 stroker build, converter, lightweight valvetrain, etc here on the channel! Definitely go check it out!
@blairalderton2238 Жыл бұрын
@@whiplashtv2022 Quick with the SBE! I’ve watched a number of your vids and have taken away some ideas for sure. Good work! Can’t wait to see what the new combo ET’s!