I ordered an EA5000P from Amazon and was sent the 6100. I use the Oregon M80 .325 chain and a 20" Speedcut bar on the 6100; love the weight. Great carb mod.
@tatepazaski5488
I've never tried the soldering method. I'm going to try that. Thank you
@thomaslindroos1667
Love it! I would wager it be more worthwhile removing the butterflies and rods and the nozzle and then boring the venturi to a bigger size. Maximum size you can bore the venturi to, is the inner diameter of the carb on the cylinder side. This has become standard practice on race boats. The carb essentially becomes a bigger carb and yes the velocity at the venturi is lower so you have to richen the jets to compensate.
@Dolmar-Rick
Nice series on a dolmar for a change instead of people raving about huskys. Must say it makes me want to go in and port my 6100 as I have never been over keen on it with it being strato and smidge heavy, but it's built a brick, though 562 isn't particularly light either. It seems like it gains a fair bit with minimal porting...👍
@AndyAlaska375
That 6100 is cookin.
@aaronpowell4885
Them darn limited coils! It's boogyin now👍🏻
@BrandonJenkins-ys6co
Love this series Boedy !!! Love my Makita
@redtiller1975
Man that thing is really cool
@crazyfeller5704
👍👍
@Leave_Nothing_Stock
Full wrap availability should count for something as well
@coolestguyontheplanet723
Good mornin😊
@Macgyver-ranch
When are you building a dyno? I know you want to.
@dmc2537
do a test with 8 pin sproket
@lennyadanfigueroasobino1921
Habrá algún carburador de Husqvarna que sea compatible con ese Makita,no logro conseguir el carburador OEM MAKITA 6100 ,BUSCO ALGO QUE SEA COMPATIBLE!!!
@andrewfitzgerald1174
Please do a whack off vs mk2 and some other 60cc!
@mustafacntrz
Ported carburator
@coolestguyontheplanet723
? I have a opertunity to buy two solo 654, no run .