Рет қаралды 39,976
In this video I open the molds and make the resin castings. Then I clean and assemble the pieces into the final model of a daspletosaurus skull.
This is part 2. To watch the first video click here:
• Molding A VERY Complex...
Thanks to Jesse for sending in this project.
Check out the Idaho Virtualization Laboratory at:
www.isu.edu/imnh/idaho-virtua...
Thanks to Starbond for providing the glue used in this video.
This is an affiliate link so if you buy glue from them it helps the channel:
www.starbond.com/?rfsn=551740...
Use the discount code Robert10 to get 10% off your purchase!
Here is a list of suppliers for the rubber, resins and waxes I use in my videos:
www.dropbox.com/s/kz6mhmf7v5v...
Do you have a project to suggest for the channel?
Here’s a .pdf with everything you need to know:
www.dropbox.com/s/pjb0l6fr7zj...
TIME STAMPS
00:00 Opening the mold cases. Continued from Part 1.
01:13 Trimming the mold flash.
01:33 Removing beeswax that sometimes gets stuck on molds.
02:20 Cutting open the molds.
05:50 Using photos as reference while cutting open molds.
12:50 Using mold cradles to help close molds properly.
14:32 Why mold cradles matter - rubber bands are not enough!
16:44 The secret to making clean castings is even, gentle pressure.
17:18 Mixing and pouring resin.
19:26 Into the pressure pot to suppress bubbles!
20:35 Bump and shake the molds to help dislodge bubbles.
20:51 Opening the molds!
25:00 Cleaning up the castings.
26:31 Assembling the skull.
27:33 Thanks to Starbond for providing the glue.
29.24 Using heat to reshape warped castings.
30:35 Using epoxy clay to fill holes and seams in the casting.
32:25 Success! The skull came out great.
32:35 Hit that like button and thanks for watching!