Chip load #2:
Рет қаралды 1,586
4 жыл бұрынDemoing some new tool changer logic and a quick code review of the Fanuc Macro B code used to execute the new logic... This is a HUGE productivity improvement for my CNC mill... And then there is the whole ULTIMATE POWER of learning Macro B!!!
Macro
github.com/Skyfire-community/...
BT30 shelf:
a360.co/2xR1Tdc
Skyfire SVM2 Spacer:
a360.co/2VpS3Ik
Visual Studio Code:
code.visualstudio.com/
@MarcPilon 4 жыл бұрын
Thank you very much for this new capability, for programming and macro explanations, for the bt30 tool holder, for Github repository setup! I have to mention that value in code is perceive by the quality of comments. You are an experienced professional sir !
@HandsonCNC 4 жыл бұрын
Thanks!!!... Yah 25 years in software development.. I may make chips as a hobby.. But when it comes to code, there is a matter of professionalism in anything I publish :-P..
@Ryan-dz3jo 4 жыл бұрын
Thanks for sharing and I admire your programming capability. Well done.
@HandsonCNC 4 жыл бұрын
Thanks..
@makosharkcnc7730 3 жыл бұрын
i just found your channel we have the same interest
Slavka Ivanov
Рет қаралды 11 МЛН
hoang quach
Рет қаралды 59 МЛН
Adi Beauty Zone
Рет қаралды 6 МЛН