Lap length & Development length | Lap length | Development length

Lap length & Development length | Lap length | Development length | As per IS-456:2000

Рет қаралды 4,173

3 жыл бұрын

Hello Everyone!!!
This video explains about what is lap length, development length with examples and guidelines to calculate lap length and development length as per IS-456:2000.
Keep watching!!!Enjoy Learning!!!

Пікірлер: 21

@sasikumartherayil9620 3 жыл бұрын

Madam Try to explain sloping slabs and their detailing forces on wall etc

@_NigmalRajas 3 жыл бұрын

Mam Bottom rod is not necessity for development length, in site we are provided only top bar.... It's crt Or wrong

@Pradeep-vl5yf 3 жыл бұрын

If slab ratio ly by lx is less than two but not supported on four sides, then it will be designed as two way or one way slab

@CivilEngineeringMastery 3 жыл бұрын

Two way slab. please refer the below link kzfaq.info/get/bejne/eZ-Xraik25rcgmw.html kzfaq.info/get/bejne/i8-kecuU0r22kZs.html

@Pradeep-vl5yf 3 жыл бұрын

@@CivilEngineeringMastery I've seen that mam, but the above question answer

@CivilEngineeringMastery 3 жыл бұрын

ok .If the slab is not supported on four sides it comes under the category of four edges discontinuous. If ly/lx less than 2 then it is two way slab.

@Pradeep-vl5yf 3 жыл бұрын

@@CivilEngineeringMastery thank you

@sasikumartherayil9620 3 жыл бұрын

For two fkur supports are compulsory

@jawaharbharani1866 3 жыл бұрын

How to design for concealed beam in stadd pro.

@CivilEngineeringMastery 3 жыл бұрын

Concealed beam concept is not advisable to use and also which is not mentioned in any of the codes.

@akashbabaria1444 3 жыл бұрын

Wht is anchorage length mam

@akashbabaria1444 3 жыл бұрын

Why lap length is considered by small dia

@CYBERxSigma 6 ай бұрын

sigma s is 0.87xfy please correct this

@famcivilengineer34 3 жыл бұрын

You are wrong about lap length Location.. Lap length should not be provided in the middle or end of the member.. Lap length should be provided at L/4 distance from end.. Ome thing more you need to elaborate this topic... Lap length for different members of rcc structure are different like for for column, beam and slab value of lap length differ.. One more question what is minimum value of dev length should be provided..

@CivilEngineeringMastery 3 жыл бұрын

Thanks for the notification. Minimum development length should be 300mm.

@sasikumartherayil9620 3 жыл бұрын

Madam think of Ld, Ld/3 Lap for tension lap for compression. In practice lapping is done wherever they like irrespective of theory.