Cleaning Cartridge Bearings Using a Lathe Then Applying Grease

No video

Cleaning Cartridge Bearings Using a Lathe Then Applying Grease

Рет қаралды 1,537

Күн бұрын

Although the bearing is clean, u must realize there is still small pits in the balls themselves from dirt and grim particles , for a bmx crank, this will be fine, if your cleaning bearings for maybe a small engine or something more critical, your better off just replacing the bearings. Cheers!!

Пікірлер: 5

@MrAndrew1400 7 ай бұрын

Nearly 2000 subs dude!!!! Well done. I think you had 12 when I started watching

@klegraefe 7 ай бұрын

Lmao 😂 I’m hitting a huge milestone 🙏🏻🙏🏻👊🏻👊🏻. I’m hoping to hit 2k this week ✌🏻

@aeroearth 7 ай бұрын

After 60 years of fooling around with model aircraft engines, motor bikes and cars, best way I have found to clean old bearings is to soak them in paint stripper containg 83% methylene chloride and17 % methanol. Diggers paint stripper in Australia. After say 30 mins. rinse under a running cold water tap/faucet, then hot water and air line blow dry to drive out any water between the cage and the balls. Test and bearing should run for several seconds absolutely freely with virtually no noise. Then immediately soak in red automatic transmission fluid and zip lock bag it. If you have an irreplacable bearing like a Rossi 15 Mk I and II rear bearing (10.50mm bore!) and it feels gritty, try soaking in Evaporust for ~ 8 hrs., then cold and hot water rinse etc.

@arthurn9237 7 ай бұрын

MY GOD WHAT A LOT OF HEEE HAWIN AROUND TO CLEAN A BALLBEARIN PULL OUT THE SEALS AND WASH WITH GASOLINE A COUPL OF TIMES AND BLOW OUT WITH COMPRESSED AIR N PRESTO LESS THAN 2 MINUTS N YOUR DUN

@klegraefe 7 ай бұрын

Really I like just playing on the lathe 😅