Clio 172 phase 1 & 2 including 182 inlet differences, advice on what to change during engine swap

No video

Clio 172 phase 1 & 2 including 182 inlet differences, advice on what to change during engine swap

Рет қаралды 12,838

Күн бұрын

Don’t buy the wrong inlet on the internet again, this video covers the differences of all clio sports from 1999-2005!
SUPPORT THE CHANNEL IT HELPS IS MASSIVELY AND ITS APPRECIATED
Facebook - Icarus Performance
Hope it’s helpful please SUBSCRIBE for more advice and tips!!!!!

Пікірлер: 14

@gregorrose8935 2 жыл бұрын

I’ve referred back to this video more than once for help. Very helpful thank you 👍

@jaysoncrichton-stuart9727 4 жыл бұрын

Great video!! Straight forward and to the point. 👍 Got yourself a new subscriber. only bit of constructive criticism is, I think in future it'd be much better if you wore a lapel mic to help the audio quality. Thanks looking forward to more Clio content.

@DustyShedGarage 4 жыл бұрын

HI DAD

@icarusperformance6306 4 жыл бұрын

Hi, we welcome constructive criticism, so thanks for that, just in response though, we are working on very low budget equipment and editing software, this is none profit (actually a loss lol) so may take time to build up good equipment. I will look into it and see what we can do!

@davidthegipsy 3 жыл бұрын

What is the difference between rs182 with rs signals inlet and 172 inlet? They have the same pod dimentsion?

@londondcpublicidad6640 21 күн бұрын

Hi! great video! I´m using a F4R that came from a sandero rs, which has the plastic inlet manifold. Will any of these 3 options fit that engine? I´m using an aftermarket throttle body, and a stand alone ECU. I would also like to know if all of them are the same height, because a lower one will help me a lot with my hood clearance. Thank you!

@samtyler9284 3 ай бұрын

I’ve just brought an engine turns out it’s a 172 engine will my inlet manifolds I’ve just had done by ms engineering now not work or can I blank the carbon canister pipe on the breather plate and use the inlet still ??

@LeonardoValente_ 4 жыл бұрын

Do you have any idea if its possible to mount the 1.6 16v inlet into the rs engine ?

@lucianocelestino8208 4 жыл бұрын

Is it possible ?

@icarusperformance6306 4 жыл бұрын

Anything is possible but as far as we are aware it’s not a straight fit, so the answer is no not without engineering work, very sorry for the late reply, we’ve been busy on other projects and will try to keep on top of comments now!

@adreesrehman5509 Жыл бұрын

If you was to delete the carbon canister, could a 182 upper inlet be fitted to 172 engine and just blank off the carbon cannister outlet ?

@fredr5at 3 жыл бұрын

what is the difference between the exhaust collectors 172 / 182 can i get an exhaust collector from a clio 3 on my clio 2 172?

@icarusperformance6306 2 жыл бұрын

Hi Fred this has only just shown up, I’m assuming English isn’t your native language, so thanks for trying as I don’t speak any other languages, exhaust collector isn’t a term I’m familiar with so must have got confused in translation, if you mean manifold, then that answer is id believe it probably will bolt up, as for fitting in the engine bay I doubt it, and the fact the mk3 has flexible joints which are a poor design and fail often I wouldn’t recommend it.