[CNC-Mill] Ep02 - JMC iHSV57 Wiring

Рет қаралды 12,836

6 жыл бұрын

Пікірлер: 25

@RF-yh3qh 5 жыл бұрын

thanks god!!! finally I found someone explaning how to build with this JMC motors... I bought 3 of them but I don't know how to put all together... :S

@stefankrimbacher7917

is it normal that green LED flashes, if only DC+ and DC- is connected to the servo?

@alejandroaguirre2355

You don't have a link to where you got the wires ? Also what are those green connections from ?

@aronvitkavendish9106 3 жыл бұрын

Дякую!

@glennedward2201 4 жыл бұрын

I want to add to this video information that is missing. First you must run 24v (no less) to the driver side for step/pulse. Anything less they will not rotate. For optimal performance the servos like 48v 20 amp supplies. For the dip switches if you plan to machine with them you need no less than 40,000 steps, preferably 51,200 to optimize torque or you will not have enough torque and trigger missed steps. For Hertz (pulse frequency) control settings these are rated at 250,000hz so you need a setting equivalent or higher. I used 400,000 in my control and anything less they will barely rotate. Anyone who wants to program theirs via rs232 I have the JMC software application to access the internal settings and I am willing to share with you just ask. As far as those connectors go they are junk and unreliable. Even if you solder connections they can come loose. There is a fix. Take some hot glue and glue the wires to the connector which will also make it water proof and prevent them from pulling out from vibration or movement.

@metalspinningworks8605 3 жыл бұрын

if i look at the wiring at the end you conect pul+ DIR+ and ENA+ of the same wire? in the maniul it tels my

@TiMechOfficial 3 жыл бұрын

hey welches controller board & welche steuerungssoftware hast du verwendet?

@Renaldo015 3 жыл бұрын

You have 7 lead cable. What happened to other 3 leads?

@ristebozhinov9588 Жыл бұрын

I want to buy the same motors, i ll use DDCS v4.1 , can you tell me where and how you connect the encoders ?

@randomname3894 3 жыл бұрын

You are a little bit wrong about the interface.. the position and alarm lines are outputs from the servo. (Notice the optocouplers in the picture are mirrored) They can pull a line to gnd, if this line is connected to a pullup resistor. (Do not connect directly positive voltage without a risistor to it.. it will be like a short)