Colby Valve Stem install, sprinter van, vanlife, overlanding, off roading.

  Рет қаралды 4,121

print4apet

print4apet

4 жыл бұрын

Last trip to Baja Mexico I had a valve stem fail, lucky it was a rear tire, lucky I noticed it in the side view mirror. I also had this same thing happen yrs ago on my Honda CBR street moto, luckily it was the rear wheel, had it been the front, I would be run over in carpool an dead. Anyhow back to the van drama. After the getting the flat I had the stem replaced, of course in Baja the place didn’t have a balancer, so a week later in a bigger city had to pay to balance. These colbys should never wear out! They also can be installed while in the middle of nowhere if you are overlanding and have air to fill the tires. They offer two versions, the 1 I share in the video, uses a 1/2” socket or open end wrench. 2nd version is there emergency, no tools required, has a wing nut built in. In any event these rock, off to Baja will see how they hold up!
www.colbyvalve.com/collection...
I bought these direct at full price, am not being payed a cent from them.

Пікірлер: 8
@bobpowell9397
@bobpowell9397 Жыл бұрын
Could not see what you were doing
@glassrootz
@glassrootz 2 жыл бұрын
Do they throw off your wheel balance
@fifiandmax
@fifiandmax 4 жыл бұрын
How have they held up? Any concerns or issues ?
@print4apet
@print4apet 4 жыл бұрын
fifiandmax just did a couple weeks in Baja it rained so was super muddy amd zippo issues. Easier to air up as well since stem is non flexy. Bought another pair to install on my street bike, as yrs ago I had a rubber one break off at 75mph
@fifiandmax
@fifiandmax 4 жыл бұрын
@@print4apet i just bought two sets of the Colby 'Ultimate' valve pairs. Hoping they are not too short for my recessed rim valve holes. Thanks for your video and info 🚙
@print4apet
@print4apet 4 жыл бұрын
fifiandmax they will work great most likely, guys are kool if ya do have issue just hit them up. Just tighten by hand do not crank the wrench or socket on them !!! The tough part can be removing the crap rubber ones
@Freestyleny
@Freestyleny 4 жыл бұрын
@@print4apet if u need to remove can u just pull them out?
@Gavin-uc3lv
@Gavin-uc3lv 4 жыл бұрын
*word
QUICK TIP: WHY YOU SHOULD NEVER USE ALL METAL TIRE VALVE STEM CAPS!
6:59
The Enthusiast Mechanic
Рет қаралды 6 М.
Comfortable 🤣 #comedy #funny
00:34
Micky Makeover
Рет қаралды 9 МЛН
Why Is He Unhappy…?
00:26
Alan Chikin Chow
Рет қаралды 71 МЛН
Borg Valve Stem Install (Sprinter 3500's)
5:46
Sprinter Tech Direct
Рет қаралды 11 М.
How to Change a Valve Stem Without Removing the Tire
10:52
Vespa Motorsport
Рет қаралды 26 М.
4x4TV Product Review - Colby Valve System
5:17
4x4TV
Рет қаралды 8 М.
How To Replace A Tire Valve Stem Without Removing The Tire
4:29
Broncos and Parts Garage
Рет қаралды 300 М.
How to Replace a Tire Valve Stem Yourself at Home with Simple Tools
5:32
FrugalPrepper's Garage and Garden
Рет қаралды 418 М.
Quick And Easy Valve Stem Replacement - No Need To Remove The Tire!
6:54
The Ultimate Upgrade For Any OFFROAD Vehicle!
14:42
Jeep Gear & Gadgets
Рет қаралды 221 М.
The Tire Valve Stem Video
4:57
briansmobile1
Рет қаралды 47 М.
Велосипед с квадратными колесами 🤣
0:44
СПОРУ НЕТ!
Рет қаралды 830 М.
Fast and Furious: New Zealand 🚗
0:29
How Ridiculous
Рет қаралды 45 МЛН
#top10 motoras humildade
1:01
DV trânsit
Рет қаралды 6 МЛН
Котенок застрял в дне машины
0:29
Up Your Brains
Рет қаралды 2,8 МЛН
😱 Защита цепи своими руками!
0:40
Тот самый Денчик
Рет қаралды 756 М.
Две старых Хонды! Оживим или на свалку?
1:32:14
ИЛЬДАР АВТО-ПОДБОР
Рет қаралды 3,2 МЛН