Coleman AT125UT Carburetor + Air Filter Upgrade

Рет қаралды 12,783

Жыл бұрын

Coleman AT125UT
PZ20 Carb + Air filter: amzn.to/3QSO3d0
NGK Spark Plug: amzn.to/3RQvPtO
Breathers: amzn.to/3qJbUB8
Socials:
/ discord
/ batahaaa

Пікірлер: 51

@HoneyBeagle Ай бұрын

Exactly what I needed thank you

@bl4565 Жыл бұрын

It runs amazing.. I Like that low idle when it not stops, but stay running at Low Idle Hope really to write with you Regards J.

@nelsoncampos43 8 ай бұрын

Thanks for the tips !!

@rolandedrummer9723 10 ай бұрын

Never had any luck with any stock chinese carb. until I fritzed with it to some degree.

@bl4565 Жыл бұрын

Whow it runs great at Idle in the End.. Low and not stalling.. It sounds so sweet. Regards J.

@Bataha Жыл бұрын

Thank you

@CyrisrossCyrisratt Жыл бұрын

@@Batahaaye bruh I have the same kind and I don’t know how to get it back running I’m just starting to get on quads

@perfectlygoodslouch5212 Жыл бұрын

Thanks for the Vid, I have the same exact 4x4 and had exaclty the same problem I ordered that carb and the only issue was with the throttle plunger inside does not fit too big for the new carbs cylinder? any ideas to check out? Thanks

@nathanrybn Жыл бұрын

when’s the new top speed test?

@Honorthelordjesus 5 ай бұрын

Hey I just bought a Coleman 200b By any chance you know why it rev it self and stay in high rev so when I change gear it kicks

@jason-tk5rs 2 ай бұрын

Great job here

@Bataha 2 ай бұрын

Thank you.

@wiley0714 Жыл бұрын

Looking at the slide in the carb, doesn't look like it opens all the way, therefore it cuts airflow and defeats its purpose...also be mindful its air cooled so running a little richer would be a cooler engine so maybe maximum air would not be a good thing. Even stock, you could have opened the idle jet and raised the needle on the slide I would think....

@Bataha 7 ай бұрын

It opens all the way, 4:29. I agree with running it on the richer side. I messed with the stock one but you can't swap jets and I tried chaning needle height, thats why I upgraded.

@shawndavidmorgan7854 10 ай бұрын

I'm doing the same thing. So, how did you adjust the throttle cable when you put on the new carb?

@Bataha 7 ай бұрын

adjust throttle cable for tightness? I didn't have to change anything

@ericberger6324 Жыл бұрын

Hay after you take off the air filter the stock one has a little rubber line that comes out and goes to inline fuel filter then in to the back of the motor when I chang the air filtter to one like you did were do you put that little hose back on

@Bataha Жыл бұрын

2:09 I but a breather on the line.

@duwaynecouch9091 8 ай бұрын

Any pictures wondering the same what do I do with that line

@FollowingMyLead Жыл бұрын

Bro how’d you add the new carburetor? I orders what you have listed and it was not compatible! The gas pedal line didn’t attack or fit yo anything. I’m ready to burn this atv to the ground 😢

@Bataha 7 ай бұрын

I'm sorry man, do you have the same 4-wheeler and have there been any mods to it?

@Nate-od6bx Жыл бұрын

I had the same issues. I installed everything you did in the video and it revs up and down at idle..I tried adjusting idle and air a bunch. Sometimes I throw it in neutral and it surges up to 5k+.. any idea?

@Bataha 7 ай бұрын

Adjust the needle height and see if it will run any better. Make sure nothing is clogging up the carburetor.

@0991sirhc1 Жыл бұрын

I have the exact same quad and ordered the same parts as you but it idles really high in neutral and I have turned the idle control screw all the way to the right. How did you get it to idle low?

@Bataha Жыл бұрын

turn the idle screw to the left to lower it.

@0991sirhc1 Жыл бұрын

@@Bataha Thank you

@egetasyapar7254 10 ай бұрын

hello, did the performance increase or decrease when I installed the new carburetor?

@Bataha 10 ай бұрын

Increase, it is way better than the stock carburetor.

@FollowingMyLead Жыл бұрын

What did you gal the spark plug to?

@Bataha 7 ай бұрын

.030"

@user-pb2lp6kq3j 7 ай бұрын

Wat happen it blew up after gaining more power?

@Bataha 7 ай бұрын

I bought it used and let it sit for awhile and couldn't start it again, because it lost compression, so I engine swapped it.

@WexyFlex Жыл бұрын

Will that all fit on the at125ex?

@Bataha 7 ай бұрын

Yes I'm pretty sure

@rickr5223 Жыл бұрын

Whats the carb you put on it? Amazon one?

@Bataha Жыл бұрын

Yes, It's linked in the description.

@ThePl87pll 7 күн бұрын

Im about lose my mind trying to figure this out. Installed everything correctly, but when I go to give it gas it bogs down and just goes blurp blurp and wont go that fast almost like its backfiring. Whats the problem??

@Bataha 7 күн бұрын

Have you tried adjusting the carb at all? Sometimes I get them and don't have to mess with them. But a lot of times I have to do small adjustments to get them to work. I'm happy to help you troubleshoot, we can do it over discord. discord.com/invite/CQyNaw8

@ThePl87pll 7 күн бұрын

@Bataha Unfortunately I don't have discord. This is my 2nd carb because the first one worked for a day or 2 and this one lasted a quarter of a mile. I tried relentlessly adjusting the little screws to get them to work with no luck lol. This atv maybe has 5 miles on it 😑. I only took the stock one out because I watched this video a while back and was like oh wow more power. Now I'm wondering if I should just buy the stock one and put that back on.

@ThePl87pll 7 күн бұрын

Well I got discord now and accepted invite, but won't let me send a message or anything.

@Bataha 7 күн бұрын

@@ThePl87pll It may be because you just created the account. So does it not start or what happened when the carb stopped working?

@ThePl87pll 7 күн бұрын

@Bataha No it starts better than ever, fires up immediately and idles perfect, but when I go to give it gas it just sputters and won't go fast.