Common Plastic Injection Molding Defects

Рет қаралды 39,030

Күн бұрын

There are many potential plastic injection molding defects, so let's explore what these are, how they occur, and key preventative measures that you should take to avoid them.
The defects include:
- Sink marks
- Weld lines
- Short shots
- Burn marks
- and more
When you know what the defects are and how to avoid them, you're in a stronger position to point out these issues to your suppliers and to push them to make positive changes.
----------------
Visit Sofeast to explore the many solutions that we offer to manufacturers and importers, such as quality inspections, factory audits, supplier management, FBA seller support, NPI, prototyping, and more: www.sofeast.com/
Our blog over at QualityInspection.org: qualityinspection.org/
Numerous FREE resources from Sofeast, a treasure-trove of useful information for importers and manufacturers: www.sofeast.com/resources/
Need help with improving results from your Asian suppliers? Contact us here: www.sofeast.com/contact-us/

Пікірлер: 14

@geoffcrumblin7505 2 жыл бұрын

This is the best explanation that I have seen. I will recommend this to my students

@SofeastLtd 2 жыл бұрын

Thanks, Geoff, we're happy you found it useful - can't wait to help your students!

@0086santosh 3 жыл бұрын

Thanks for the information! Can u please add a video covering shrinkage of plastic

@tiffanybowman6541 8 ай бұрын

Thank you for making this video it is very informative

@dansorescu5720 4 жыл бұрын

very informative video. thank you!

@SofeastLtd 4 жыл бұрын

So happy you found it useful! :)

@dansorescu7504 4 жыл бұрын

@@SofeastLtd looking forward to more videos on injection molding :)

@jinnahkeeranur 4 жыл бұрын

Sir i need more knowledge both injection moulding and technical knowledge

@khalidsayed6659 3 жыл бұрын

Anyone knows about air venting in mould??

@Vijaysmdn 4 жыл бұрын

Can you sent this ducoument its very useful

@DustinBai 3 жыл бұрын

Good

@mohammedubaid1323 2 жыл бұрын

Can anyone tell what is box effect of plastic

@williamjimenez2821 4 жыл бұрын

could you tell me please what happen if the parts sticking on the front half if not hAVE ejector pins

@OffGridInvestor 3 жыл бұрын

Ejection pins OR air pressure used to spit the part out are the standard ways. If the design of the mold is straight sided not slightly angled LARGER towards the opening side, it will often get wedged in the mold. The idea being that it will eject easily if it's slightly like a triangle with the pointy end inside the mold and the flat side on the side it ejects out of. Only has to be like a 2 degrees angle for this problem to be fixed.