Compiling and Uploading Firmware and Fine-Tuning - Atomic U300 Marlin Firmware Setting Part 2

Рет қаралды 1,478

Күн бұрын

In this Part 2 video, I will show you compiling and uploading the Marlin 2.0.x firmware.
And this video also covers the fine-tuning process including Calibrating Z probe offset, Bed leveling Optimization, and PID Auto-tune.
You'd better watch the Part 1 video if you are interested in the Marlin firmware setting.
0:00 Intro
0:53 Compiling Marlin 2.0.x with Arduino IDE
1:41 Compiling Marlin 2.0.x with VS Code
1:45 Installing VS Code and Platform IO
2:51 Importing Marlin-2.0.x File
3:20 Checking and Editing Customizing Items with VS Code
5:07 Compiling and Uploading Marlin Firmware with VS Code
6:01 Installing the ‘Printrun’
6:51 Checking the End-stops
8:02 Checking the X and Y motors
9:42 Checking dual Z-axis motor
11:03 Calibrating Z probe offset
13:17 Bed Leveling Optimization
16:09 PID Auto-tune
19:21 Checking Extruder motor
Music
Hey - Bensound
Sophomore Makeout - Silent Partner
Sugar Zone - Silent Partner
Perception - Bensound
Hipjazz - Bensound
Fork and Spoon - Kevin MacLeod (incompetech.com )
Rock Your World - Audionautix
Bright Future - Silent Partner
Morning Cafe - Camtasia Library

Пікірлер: 9

@josegb3453 2 жыл бұрын

Excellent work !!! thanks for the video.

@MakeTogether 2 жыл бұрын

Thank you for your comment, Jose.

@hamzajamal5661 Жыл бұрын

Hi, can you please share the exact marlin file that you have shown here.

@hamzajamal5661 2 жыл бұрын

Hi, is it possible to tell marlin that I have 2 y axis stepper motors, instead of just the one? Its a single extruder, single z & x motor but dual y axis assembly.

@MakeTogether Жыл бұрын

Thank you for your question, Hamza. You can use 2 Y-axis motor with a dual motor adapter.

@josegb3453 2 жыл бұрын

I see that in step 3 choose Ramps 1.4 as motherboard, if I have a Ramps 1.5 can I do the same as you did?

@MakeTogether 2 жыл бұрын

Yes, I also use RAMPS 1.5 and choose 1.4 in Marlin.

@esaumorenomurillo9011 2 жыл бұрын

When connecting with Printun how it automatically loads the printer information is found at minute 7:11

@MakeTogether 2 жыл бұрын

Thank you for your question, Esau! If you select the correct "Port number" and "Baud rate", the program will connect your printer. After connecting the printer, it automatically loads the setting values in your printer. Or you can use "M503" G-Code. Any time you type and enter "M503" in the console bar, it loads all the setting values.