A) The external one is not a “controller” but an H-Bridge drive. B) PWM is not a form of communication but Pulse Width Modulation that allows the Motor power supply to be “chopped” on and off in order to get a DC mean voltage “modulated” or adjusted betweenness -Battery Voltage till + Battery Voltage

Thanks again, goBILDA for helping us progress along the learning curve with useful "jumpstart" demonstrations. Wish you could do the same with some of your mechanical components (other than Viper slides) like intakes and shooters. Different team, I guess.

Creative video, thanks :)

What about 220v brush motor with 30W(small fan)

Be great to see a six motor (mars rover) project with route mapping and obstical avoidance

Nice! In struggles with getting those speed controllers to work and gave up and bought some other controllers. Now I can use the gobilda esc’s. Thank you!!

Thank you for the extra code- it’s very helpful!

Interesting 👍

can you explain/tell the same thing but for dual channel (4 motors) esc?

Very helpful - thank-you!

Love this video!

I was curious about map(); this isn't std::map but an Arduino-specific function which deals in integer arithmetic, part of the Arduino framework functions (hence no import needed). Or so I think!

Is it a problem if the motor drive i wanna use has a CAN bus comunication protocol? I am aware that it is not the comunication protocol of arduino

@goBILDA Does this work with 3.3V logic level PWM? Or only 5V?

How would I add an AS5600 encoder to this code