No video
Control your spindle via PWM on Shapeoko
Рет қаралды 3,996
2 жыл бұрынAre you wanting to control your PwnCNC Spindle kit from your Shapeoko controller? This video is for you.
@ClintonCaraway-CNC 2 жыл бұрын
Great job explaining everything!!
@ForeverandEverWoods 2 жыл бұрын
As Always - Great Job!
@DADT12 Жыл бұрын
This is a great video but where do you have this manual. The one I have only has 15 pages.
@PwnCNC Жыл бұрын
The manual was simplified to prevent any confusion. There is a ton of information in this first manual which can be found in our KB: support... support.pwncnc.com/kb/section/8/
@karlgabel9822 Жыл бұрын
It's been a year - has this been re-recorded yet? Thanks!
@rrshoeing 2 жыл бұрын
Great video! Where did you get your Spindle. I see it's air cooled. Why didn't you get a liquid cooled?
@PwnCNC 2 жыл бұрын
I designed the spindle kit myself (pwncnc.com/products/spindle-kit). On this particular machine I didn't want to deal with the coolant bucket etc. On a few other machines in my shop i did install water-cooled spindles. I'm also working on a very special closed-loop coolant system to offer to folks as well.
@rrshoeing 2 жыл бұрын
@@PwnCNC Thanks
@brianwy77 2 жыл бұрын
Good video, do you have plans to make a adapter that allows you to run your bit runner along with the PWM. I use my bit runner to control my pump and dust collection now they I have the spindle.
@PwnCNC 2 жыл бұрын
Unfortunately Spindle control and the BitRunner are incompatible with each other. We do have plans and working on triggering an IoT relay from the vfd, however truly this would ideally be solved on the controller side.