The crew and I cut the stub tower off an 8ft motor tower to convert it into a 10ft stub tower and platform.
Пікірлер: 18
@gaildimick1831Ай бұрын
That’s hard labor, what a small platform to stand on. My 10 foot mill has a 2’ wide walk around platform. I can use a 6’ step ladder on it, to get up to the helmet. Nice video.
@yourlocalwellmanАй бұрын
Oh yeah, some of them are sketchy! That sounds like a very nice one to work on! Appreciate it!!
@luisaparecido58856 ай бұрын
Parabéns 👏👏👏👏. ótimo trabalho 🇧🇷
@yourlocalwellman6 ай бұрын
Thank you!
@cucukikiable Жыл бұрын
I love old and dirty windmills ♥
@yourlocalwellman Жыл бұрын
Me too!
@martinbyrne6643 Жыл бұрын
Hurry up , them cattle need water 😊, do you hear them roaring.
@yourlocalwellman Жыл бұрын
They only like the sight of two things, the feed truck and the Well-Man lol
@jodyrayvictor5 ай бұрын
What is the deciding factor for switching from an 8ft to a 10ft mill ,or any size in general? P.s. love what y'all do
@yourlocalwellman5 ай бұрын
It mainly depends on how deep the well is. Anything over 100 ft people start considering 10 ft motors for the extra pull power and less wind to start spinning! Thank you, we really appreciate it!!
@miguelangelvalderrama1808 Жыл бұрын
That pond has earth in it 🤨🤨🤨🤨
@luizamerico2742 Жыл бұрын
👏🇧🇷🇧🇷
@mrbigdad84 Жыл бұрын
What was the reasoning for the conversion? Well deep enough to require the increase pump power?
@yourlocalwellman Жыл бұрын
The only reason we upgraded it was due to the 8ft motor going bad and the rancher happening to have a spare 10ft motor laying around
@kmeyer5598 Жыл бұрын
So, an 8 ft motor will handle a 10ft wheel? If so, then you needed to lower the platform, correct?
@yourlocalwellman Жыл бұрын
Sadly, no, what we did in this video was cut the stub tower off from the 8-foot motor and completely replace it with a 10-foot stub tower and motor, which is why the platform is lower on it!
@kmeyer5598 Жыл бұрын
Makes sense. Do you rebuild any of the Aermotor engines?