On how to replace grain conveyor broken bearing step by step on jobsite shown on video. Follow simple procedure on how I replace broken bearing. Thanks for watching #jambasicskills #conveyorbrokenbearingreplace
Пікірлер: 25
@Petesworkshop222511 ай бұрын
Dude.... use a brass hammer whenever working on shaft/bearings.
@900fam11 ай бұрын
At least a piece of wood to hit on instead of the bearing itself. Also noticed the grease fitting being trapped on the bottom.. he should of put the bearing on with the fitting on top so that it can get grease when needed.
@jambasicskills197010 ай бұрын
Yes that was correct but sometimes it doesn't follow the basic rules Thanks and noted next time@@900fam
@brianberson416910 ай бұрын
I'm new to it what would u use rubber mallet.
@gumin72125 ай бұрын
감사합니다 !! 회사에서 베어링이 가끔 고장나서 교체를 해야하는데 하는 방법을 몰라 혼났었는데 덕분에 배웠습니다 !
@jambasicskills19703 ай бұрын
Thank you Sir
@cyh89534773 ай бұрын
^^
@grierhawkins8514 Жыл бұрын
That's good 🙂
@randytodd63092 жыл бұрын
Informative 👍
@jambasicskills19702 жыл бұрын
Thanks 🙂
@nashcay-an47962 жыл бұрын
good job 👍
@jambasicskills19702 жыл бұрын
Thanks
@user-mz6xe5ym3w9 ай бұрын
Okay, that's actually easier to follow 😮
@jambasicskills19707 ай бұрын
Yap.. If frequently or your routine in field
@rhiagorgetv5458 Жыл бұрын
😊👍
@jambasicskills1970 Жыл бұрын
Thanks
@vishyandypurandat62085 ай бұрын
Nice job only one thing I'll do differently is using a brass hammer.
@jambasicskills19703 ай бұрын
Yes Buds, you can use any hammer as long as you are comfortable using it. Thanks
@A1_filmsss8 ай бұрын
Next time use a soft face hammer to drive your bearings on and that’s an eccentric locking collar on the bearing. You’re suppose to use a punch in the hole that the set screw doesn’t go into and tap it around in the direction of shaft rotation.
@jambasicskills19707 ай бұрын
Your correct buddy. video shows how to do it in basic ways but it's up to maintenance guy how they provide proper tools for every project available.. in that time we did just to run it for it will needed it very badly in the middle of busy operation..
@chazchampion42812 ай бұрын
So the bearings don’t need washers?
@jambasicskills19702 ай бұрын
Nope but its up to you if need so
@danknoll36137 ай бұрын
He forgot to grease the new bearing.
@danknoll36137 ай бұрын
And also forgot to put his personal lock on the disconnect.
@jambasicskills19707 ай бұрын
Yes Buddy. I ms to show in my video about installing LOTO before starting the project. Thanks for reminding me appreciated.