Corset Tutorial Part 5 | Installing Liner & Draping

Corset Tutorial Part 5 | Installing Liner & Draping | How-To with CassB

Рет қаралды 3,088

7 ай бұрын

Boning: @WAWAKSewing
Sparkle Tulle: @secretspark
Seamstress Chalk: Amazon Storefront: www.amazon.com/shop/cassbbyde...
(seamstress chalk listed under the "Sewing and Garment Construction" list")
Background Music: @audiolibrary_

Пікірлер: 12

@patanco13 7 ай бұрын

Amazing as always. I watch the video a couple of times to make sure I saw every bit of it.

@cassbbydesign 7 ай бұрын

Thank you so much I love that you’re enjoying these videos❤

@Justhamom 4 ай бұрын

So pretty in blue:) Beautiful and beautifully constructed corset. Love the sparkle fabric!

@mimimesa3077 7 ай бұрын

YES I needed this tutoriall sooooo badd thank you so much for what you do 👏👏🙌🙌🙌

@cassbbydesign 7 ай бұрын

Thank you so much I’m so pleased to I enjoyed it and found it helpful!

@JenniferAnidu 7 ай бұрын

Enjoyed watching! The draping part I wanted to learn more! Can you show how you cut in on bias thank you

@cassbbydesign 7 ай бұрын

Great idea! I'll add another draping tutorial to the lsit for upcoming videos

@MoreStephanieHarford 7 ай бұрын

It's looking so good! Your vibe is totally my vibe! Would love to connect as a fellow dress designer, I love supporting others :)

@marierosettemikulu4625 7 ай бұрын

Beautiful tutorial. Did you sew the lining at the neckline only before applying the draping?

@cassbbydesign 7 ай бұрын

thank you so much! and the answer is yes. If you take a look at the next video you'll see me hand sewing it down being careful not to pierce through both layers of the fashion fabric and lining. Check out the newest video and let me know what you think!

@jenniferkeller9421 7 ай бұрын

What happened to the interfacing strips you cut in the first video or two to put onto the boning?

@cassbbydesign 7 ай бұрын

Great question. The interfacing tabs i cut in the first video were originally intended to be ironed on to the tips of each piece of boning before sliding it into the channels. They can also be cut into a curved edge and melted. This is the method i last minute decided to go with instead of the tabs because i stitched the channels slightly tighter and the melted edge made the boning slide into the channels more easily than the tabs. Great eye!