This is awsome helped me and my grandpa put this thing together we didn’t get no instructions

Not bad, first one I've seen that I wasn't getting angry watching someone assemble a new implement! Good approach and methodical about the assembly. That retention pin attachment on the gearbox PTO shaft I see as critical. They seem to be wobbly enough during perfect operation. If something happened where the pto shaft separated with engine power on connected to the tractor, thats a lot of steel flying around before shut down! You are the first one I found that showed that retention pin, I hope others know how important that is incase the shear bolt brakes that is the only thing holding it on until shutdown. Thanks for uploading your video.

To get all of the dirt out of the hole, stop the auger while it's in the bottom of the hole, then lift it up. This way the dirt stays on the auger. Then move the tractor a bit then clean the dirt off the auger.

Please go to Harbor Freight and get a 3/4 drive socket set and a medium sized pipe wrench. Just the things to tighten those hitch pins.

Hole-lee heck that's a big auger. That will make the tree planting easier for sure. Good vid, thanks. FWIW I use a 4" auger (hand-held) for my fence post.

Can’t wait to see the planter box! Be sure to post a link😁

Buying on of these and same size auger tomorrow. For Kubota L3902

Cool video, I just bought the same post hole system, I’ve never used a three point hitch yet so this will be quite the adventure 😂 but I’ve learned a lot by watching KZfaq videos like yours! Thanks for the great video!

Sometimes the plastic sleeve won't stay on the PTO mount at the tractor and sometimes it goes on and won't come off. Is there a secret tab I'm not using?

I found that when i initially installed boom on my 25 farmtrac the auger bit was barley off ground so i put bolt in 1st hole which made auger bit sit up higher for travel around prop..also auger is working but i dont like the jerky motion when raising and lowering,,are you having same issues

Got to grease two fittings on top plastic (drive shaft ) plastic bearing housing

Thanks for leaving in your mistakes. I would have installed the guard before the driveshaft as well and had to take it back off. Don't ya hate it when that happens? 😂

Is it an extendable shaft, or did you have to buy an extension separately?

Why do you put the yope

Mine doesn't dig beyond 1 foot

This was painful to watch. I have the same one and it took like 10min to put on. And that was AFTER removing my quick hitch. It was like you chose the hardest way possible to do each step. lol

Can’t wait to see the planter box! Be sure to post a link😁