My lord -- wow. Your hand shaped light-wind wing-foil board video knocked my socks off, and this one is a master class in repairing a foil board right. Bravo.
@jmp299 ай бұрын
Kudos for taking on the challenge, your DIY repair and creation is truly an inspiration for me (just like with all your videos!) Thanks for taking the time to share (and edit video !) !
@wharfrat57809 ай бұрын
Awesome repair.
@rmoisio9 ай бұрын
amazing concepts and innovations in this video
@iamkian9 ай бұрын
You make it look so easy! Thank you for sharing 🤙
@youdigsurf9 ай бұрын
technique de jedi ! j'ai vu tellement de réparations faite par des shapers pro qui n'était pas aussi bien faite ! gros travail quand même !
@windaddict9 ай бұрын
Wow, lots of work. Good job!
@florian3679 ай бұрын
Toujours au top ! Je pensais pas que le sillica se poncait aussi facilement.
@matshape9 ай бұрын
moins facilement que les microballons, mais avec le "mesh sanding disc" ca passe bien.
@youdigsurf9 ай бұрын
je viens d'acheter une board et j'ai une réparation du style, question bête mais quand tu lamine à plat le patch du début c'est quoi le film transparent que tu utilise ?
@matshape9 ай бұрын
une chute de vacuum bag, juste pour ne pas mettre de la résine partout :)
@davidshlimak39029 ай бұрын
What sander and disc are you using? Looks to do a good job at removing material on curves
@matshape9 ай бұрын
not sure how the sander is called, but it just rotates, not random orbital. But the disc is what makes the difference, they are nets, they stay clean and sharp much longer
@magnusnr839 ай бұрын
Nice work 👌 Question: Would water sticking to the mast after sanding be better for laminar flow?
@matshape9 ай бұрын
yes, it probably does, even if at our speeds the impact might not be huge, in this case, it's also to smooth out the surface after the last full coat of spray to remove the tiny droplets pattern and get a consistent surface.
@norfolkfoiler64669 ай бұрын
How did you manage the colour match with the paint there? You suddenly managed to darken the paint to match.. was it a better matched colour in a different can?
@matshape9 ай бұрын
with some luck: last board of same color I fixed, the paint I picked was too dark, the new paint I picked for this one was too light, so I ended up going alternating dusting of both until the balance was kind of right :)
@arthurmldt9 ай бұрын
t'utilise quoi comme top coat pour le mat ? belle repa
@matshape9 ай бұрын
C’est un vernis acrylic, un peu plus cher que rustoleum, mais le spray de celui la est bien plus propre.