Cue Making - trim rings
Рет қаралды 140,852
12 жыл бұрынMaking veneered stitch rings to match your custom cue: from making the billet to slotting it & parting off the individual rings. This might give you some insight into the amount of work that goes into this little detail that helps make your cue special.
If you have ANY questions, please contact me thru my website as I will not respond to comments here. www.dzcues.com/
@L.Kneemoy 8 жыл бұрын
I really love your work Bob, very nice cue indeed, excellent color combination veneers and ring work look great. Always like your cue building videos.
@K8Nicole 11 жыл бұрын
Yes. These are awesome videos. Thanks for posting dzcues.
@managingothers5573 4 жыл бұрын
Master Machinist.........EXCELLENT work!
@vancedewitt336 7 жыл бұрын
I'm interested in building; cue making. Here to see what it's going t take. Simple enough. I like the subtle craftsman tricks, sanding the ring while it's still supported, catching the ring with the hex key. This color combo is very attractive, and your finished work is beautiful. I enjoyed watching you work. Where is that Subscribe, aw yes there it is. click.
@kimbye1 11 жыл бұрын
Love your videos! I wanna build cues too :)
@johnnyp6202 6 жыл бұрын
Bob, did you ever take pics of the finished cue? Would love to see it
@jayzbond007 9 жыл бұрын
Yourr cues are beautful and thus one of a kind. do you have a website for purchase of your cues?
@kennethbishop123 6 жыл бұрын
I have a 48 inch wood lathe and I am wondering what attachments I need to buy for cue turning. Benchmill maybe? Where to get one?
@MrElPoderozo1 8 жыл бұрын
Where can I buy one of your cues? thanks.
@markorantanen 11 жыл бұрын
Hi, what kind of paper are you using on this?
@chessguru900 7 жыл бұрын
how do you get that glossy sheen on the cue?
@American_Made 5 жыл бұрын
clear coat. usually polyurethane , car finishes. seal first with good sanding sealer, sand with paper down to 600 grit, spray the cue with quality clear. after it's dry wet sand on a lathe with 2000-3000 grit wet sanding paper with lots of clean water from a spray bottle to prevent trash from scratching your finish. then polish with a good rubbing compound. I use 3m products.
@dominicpiscopo4498 8 жыл бұрын
I would love a custom made cue but probably wouldn't be able to afford it?
@SQ_og 3 жыл бұрын
Is that a cobalt parting tool?
@poolsicario5882 2 жыл бұрын
Any site where i can check your cues?
@dzcues 2 жыл бұрын
Doesn't anyone read the descriptions under videos?
@ecahhumaeroh1198 3 жыл бұрын
Memakai lem apa itu bos
Studiotronics
Рет қаралды 117 М.
Niels The Terminator Feijen
Рет қаралды 200 М.
Mulhollen Billiards Channel
Рет қаралды 33 М.
Rozetked
Рет қаралды 481 М.
Nir Gaming
Рет қаралды 2,2 МЛН
Sameer Gaming
Рет қаралды 1,8 МЛН