Cupholder Removal, 2014-2018 Toyota Corolla

Рет қаралды 11,824

2 жыл бұрын

Step by step how to remove the cupholder from the center console in a 2014 Toyota Corolla. If you spilled your drink and your cupholder is dirty, you can remove it and wash it, to make it look like new!
⚠️ DISCLAIMER:
Use of the information in this video is solely at your own risk. The creator of this video assumes no liability for any property damage, injury or expenses incurred as a result of any of the information contained in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result.
The creator of this video makes no claims, promises or guarantees about the accuracy, completeness, or applicability of the procedures and instructions contained in this video.
Any injury, damage, or loss that might occur as a result of improper application, improper use of tools or equipment, or from the information contained in this video, is solely the responsibility of the user.

Пікірлер: 22

@CleverFix 2 жыл бұрын

If you enjoyed the video, please give it a *thumbs up* 👍. Your support helps me create more content and is *greatly appreciated* . If you have any *questions* , *comments* , or *suggestions* for future videos, feel free to leave them below. I love hearing from you and look forward to your *feedback* !

@larrycroft470 2 жыл бұрын

I really enjoy your channel. I am a new subscriber. I have a 2016 that i just bought for my daughter. Your videos have been very helpful for me to better understand how to take care of it. Great job Brother!!

@CleverFix 2 жыл бұрын

Glad you like them, thank you!

@Biblereader919 26 күн бұрын

Amazing video. Thank you so much

@CleverFix 22 күн бұрын

I'm glad you liked it, and thanks for watching!

@pierretessier1682 2 жыл бұрын

Thanks a lot. With this video, i can adjust my parking brake lever whitout damagijg my cupholder!

@qit1 2 жыл бұрын

You are great Thank you 💗

@scrappy1859 Жыл бұрын

Thanks 👍

@mohdotnet Жыл бұрын

Brilliant thank you so much for this. Please can you show how can one replace the shifter bulb? I suspect it is below the trim

@CleverFix Жыл бұрын

Do you mean the lever or the knob on the top? The knob on the top just unscrews out.. turn it counter clockwise.

@HPVP77 2 жыл бұрын

I have a 2014 Corolla LE, and I have just the basic Entune stereo. how would I add graphics to my screen instead of the ones that pop up. and when I shut the car off how do I keep a graphic on the home screen?

@_Lords_7 Жыл бұрын

Do you have a video on how to remove the cigarette lighter? I'm trying to replace it with a dual USB port.

@CleverFix Жыл бұрын

I don't have it but I'll make one, should have it up in the next day or two. It's likely not too easy to replace it unless you cut the plastic once it's out,.. My Corolla has a single USB port there already next to the lighter, maybe you have the connector for it, and you can get the port from a junk yard and just plug it in. Anyway, I'll make the video soon.

@_Lords_7 Жыл бұрын

@@CleverFix Thank you sir. I have the lighter socket loose but there's not enough slack to pull it out enough to unplug it.

@joewhattoff8754 2 жыл бұрын

Were you born in the United States? I can't quite place your accent

@CleverFix 2 жыл бұрын

East Europe!

@CleverFix Жыл бұрын

Hey, The Krickit should be actually used at the bottom between the Crankshaft and compressor pulleys, not at the top, that's probably why the tension seemed low,.. I just figured it out, I'm gonna check it again today. So the bottom cover has to be taken off to check.. it's probably not a huge difference in reading,... and down there it's actually easy to press it on the belt.

@CleverFix Жыл бұрын

On an engine without AC the tension can be checked at the top next to the engine mount.. probably because there's nowhere else to put it.

@CleverFix Жыл бұрын

Ok testing at bottom pulleys and top gave very similar results.. but technically it should be done at the bottom.

@CleverFix Жыл бұрын

Also, I put the tension bolt back to original position and I get about 80lbs, just like you're getting.