Cut & Lift Difficult Concrete W Foam Cans, Part 10, FnF464,

Рет қаралды 8,778

FriendnFamily

3 жыл бұрын

FnF464210516, Cut & Lift Difficult Concrete And Car W Foam Cans, Part 10

Пікірлер: 13

@cani6767 3 жыл бұрын

I like the saw trick wasn't expecting that! Love these lift video results.

@friendnfamily9053 3 жыл бұрын

Glad you liked it!

@Jake-tq2vr Жыл бұрын

How do you keep from putting to much foam an making the sunken piece now higher then the other? Like if you put to much won't it just rise above original sitting place?

@theelectriciansapp7802 2 жыл бұрын

I can't get enough of these videos, good job man these could easily blow up to millions of views. Could you try a driveway soon?

@cclcanadiancountrylife3628 3 жыл бұрын

im on part 10 now....ive seen enough...heading to home hardware to buy out their spray foam supply

@jachinvalentine 3 жыл бұрын

save me some lol

@tyvancouverbb Жыл бұрын

did anyone try to diy their driveway?

@profuse007 3 жыл бұрын

You do realized that in a month, there's gonna be thousands of video like this

@1921120 2 жыл бұрын

Why did you put your car above the working area before injecting the foam? Thanks.

@friendnfamily9053 2 жыл бұрын

Hi, thanks for asking. There were viewers who wondered if the foam could be easily crushed. Putting the car above the working area was demonstration that the foam can have quite a lot of lifting power and not easily be crushed.

@1921120 2 жыл бұрын

@@friendnfamily9053 Thank you for answering. It seemed the foam is very powerful. I tried two cans, but not working. I guess I need to cut the line as you did.

@nancytc1 3 жыл бұрын

How do you know where to drill the holes in the concrete? For this one, it looks as though the dip is on the right, but you drilled the holes in the middle and the left side. Do you always go opposite the dip?

@1921120 2 жыл бұрын

Same question here.