Della Mini Split Installation
Рет қаралды 4,824
Ай бұрынFirst off, this unit is working great for me. It has been installed for 3 weeks.
This is a 12000 BTU unit. There are several Della mini-split installation videos on KZfaq. I did this video to show some of the steps and installation surprises most other videos gloss over.
I installed this unit about 1 week before uploading the video, and so far it's worked great. It easily cools my garage, even in the afternoon when the full sun is on my garage door. But don't expect it to cool you entire house. It's not that strong. And, my garage door is insulated with a foam insulation kit that works great to block heat.
The Della installation is not hard if you're good at light carpentry and experienced with electrical installations and air-conditioner Freon lines. If you don't have experience with these things, then hire someone who does.
Amazon link to the Della unit: amzn.to/3VDZU4g
Link to the foam insulation: amzn.to/3RsEQeB
@cristianrodriguez3831 16 сағат бұрын
What is the adapter size too pull the vacuum is is 5/16 or 1/2 inch adapter
@stickyfrog 16 күн бұрын
@scottswinda The Della unit is charged but the lines comeing from the indoor unit are not charged like a MrCool mini.
@MikeM100 15 күн бұрын
That's why pulling a vacuum is necessary. I got an AC installer friend to pull the vacuum for me and he confirmed that it needed to be done. I wanted to put that in the video, but he didn't want to be on camera.
@scottswinda4727 16 күн бұрын
Hey if that mini split is precharged it shouldn't need the lines vacuumed
@MikeM100 15 күн бұрын
The lines are open to the air. If you don't pull a vacuum then air will be in the lines, which will degrade it's performance. That is also in the manual. I got an AC installer friend to pull the vacuum for me and he confirmed that was the case.
@tomdutcher195 2 күн бұрын
@@scottswinda4727 Non-condensibles are one of the biggest problems with compressor failures.
@stickyfrog 16 күн бұрын
The one part I needed to see you don't show.
@MikeM100 15 күн бұрын
What do you need to see?
@joseteran9738 15 сағат бұрын
La parte que quería ver no la enseña 👎🏻
@joseteran9738 15 сағат бұрын
I want to se da vacuum part
@tomdutcher195 5 күн бұрын
you should never us loctite on flare fittings
@MikeM100 5 күн бұрын
Why not? I would like to know. I always have and never had any problems from doing it. My AC guy said to do it.
@tomdutcher195 4 күн бұрын
@@MikeM100 it goes against best practices, loctite should never be used on brass fittings
SethCraft Workshop
Рет қаралды 6 М.
超人夫妇
Рет қаралды 40 МЛН
Everyday Home Repairs
Рет қаралды 314 М.
Red Beard Engineered
Рет қаралды 593 М.
Benjamin Sahlstrom
Рет қаралды 129 М.
Trial N' ERROR
Рет қаралды 995 М.
Tony's Tractor Adventure Homestead
Рет қаралды 8 М.
Shanith Janatha
Рет қаралды 32 МЛН