Рет қаралды 14,012
Есть итальянский замок для межкомнатных дверей с механической защелкой, а надо сделать его магнитным. Вот такую задачу поставил заказчик. За основу взят магнитный замок но большего размера. Разобрали оба и начали кумекать, переделали защелку, установили в нее магнит, сделали вставку, которая сузила размер отверстия. И вуаля). Но не все так было просто, магнит надо было установить под таким углом и на такую глубину чтобы это работало иначе он то не вылазил, то не залазил, то еще куда нибудь примагничивался)))
Печатали детали на anycubic kobra 2 pro, пластик PETG от компании 78125 заказанный на ОЗОН, кстати неплохой пластик, минус что без катушки, но качество хорошее.
There is an Italian lock for interior doors with a mechanical latch, but you need to make it magnetic. This is the task set by the customer. A magnetic lock is used as a basis, but of a larger size. They disassembled both and began to bake, redid the latch, installed a magnet in it, made an insert that narrowed the size of the hole. And voila). But not everything was so simple, the magnet had to be installed at such an angle and at such a depth so that it would work otherwise it would not climb, then it would not climb, then it would magnetize somewhere else)))
We printed parts on anycubic kobra 2 pro, PETG plastic from 78125 ordered for OZONE, by the way, not a bad plastic, minus that without a coil, but the quality is good.
#3dprinter #3dprinting #3дпечать #anycubic #anycubickobra2pro #ozon #3dcxema