1. Clean surface of all dirt, oil, or anything that may affect the adhesive bond. Be sure to really clean the edges and corners as this will be the first area for the decal to fail.
2. Remove entire vinyl skin from release liner
3. Lay vinyl over top of the device
With this unique adhesive, it is recommended to let the adhesive touch the surface. You can still be able to slide the vinyl around until you have the ideal position.
4. Once you are happy with the position “LOCK” the decal in place by creating a “hinge” somewhere in the center and work your way out.
5. Apply the rest of each side of the decal pushing from the center out.
6. If you notice any air bubbles in your installation begin to push them around with your fingers until they disappear. Our unique adhesive has air channels that allow the air to escape. Allowing for a bubble-free installation! If you notice that some bubbles do not go away you can pop a hole in the vinyl on the outer edge of a bubble, and push the air from the other side towards the hole in the vinyl.