Dirt Bike Shock Rebuild

Dirt Bike Shock Rebuild - DISASSEMBLY

Рет қаралды 27,337

Күн бұрын

If you have never rebuilt a dirt bike shock, you NEED to watch this video. This video is geared toward those who have never rebuilt a shock. All the details and common mistakes shown. In Part I, I tear down the shock and explain all the processes in detail so you won't make any mistakes on your own.

Пікірлер: 15

@dancampbell6958 4 ай бұрын

Finally I found a video where they don't have $150 in special tools to rebuild the damn shock.

@brian.d.mobley 4 ай бұрын

Ha! I try to use “normal” tools as much as possible! Thanks for watching!

@hyperrhino9258 Жыл бұрын

Thank you for showing this shock rebuild. This is very similar to a 150r setup, so much appreciated.

@brian.d.mobley Жыл бұрын

Sure! That’s a really old video so I’m glad there are people out there that can benefit from it. Thanks for watching!

@ReganCampbell-tp2lx 3 ай бұрын

Can you replace the bumpstop without pulling the shock completely apart

@brian.d.mobley 3 ай бұрын

Unfortunately, no. 😢

@omarmonoruiz 4 ай бұрын

badass $$$

@brian.d.mobley 4 ай бұрын

Glad you enjoyed it

@davidpalmer287 3 жыл бұрын

If you have and handheld air pump you can put it on the schrader valve and give it a pump the bladder will pop right out, its a little bit messier that way but ive had bad luck with snapping valve stems.

@brian.d.mobley 3 жыл бұрын

Hey David. I never have had trouble getting the bladder off, but thanks for the tip! And, thanks for watching!

@davidpalmer287 3 жыл бұрын

@@brian.d.mobley Really? Almost every shock i have done they have all been a major pain to get out but they also have been way beyound their service life. But I appreciate all the videos you make, they are very imformative.

@brian.d.mobley 3 жыл бұрын

@@davidpalmer287 Maybe I have been lucky! What I DO have problems with is getting that dang seal on that goes around the piston. I do a lot of cussing when I work on those! HAHA!! Thanks for watching my videos! Im so glad they help! Its very satisfying to know you can help others with stuff like this.

@davidpalmer287 3 жыл бұрын

@@brian.d.mobley Yea. Those suck. Ive been using the low friction ones that mx tech offers they are cut with a little alignment notch in the center so the ends mate back up.

@brian.d.mobley 3 жыл бұрын

@@davidpalmer287 I have been using the same! So much easier. But they dont make one for every shock.