se poco ingles amigo pero prometo ver el video mil veces hasta entender como hacer el angulo de corte. muy agradecido por compartir este conocimiento con tanta paciencia. saludos desde Lima Perú

Thanks for your wonderful videos. What's the name of block you use after sharpening the blade? I mean what kinda material is that?

Hey, bro, what's the number of the powder used for sharpening?

THEREFORE, WHAT MEASUREMENT OF HALLOW CURVE IN MICRON DOES THE BLADE HAVE?

WHAT IS THE REQUIRED HOLLOW CURVE IN A BLADE THAT SPRING TENSION CAN OVERCOME BOTH BLADE CURVE TO EXERCISE CUTTING? BECAUSE IF, TOO MUCH CURVE OF BOTH BLADES, ( COMB AND CUTTER) THE TENSION SPRING WOULD HARDLY PUSHING DOWN TO THE CUTTING SPOT. IF, LESS CURVE, SPRING TENSION WOULD HARDLY REACHING DOWN TO THE CUTTING SPOT. WHY? IT BECAUSE BOTH BLADES ARE ALMOST FLAT TO FLAT RUNNING MOTION.

How can I get this

interesting!

Am interested

I'm to Rwanda, why can buy that machine bosse.

are you high

Thanks for your wonderful videos. What's the name of block you use after sharpening the blade? I mean what kinda material is that?

Thanks for your wonderful videos. What's the name of block you use after sharpening the blade? I mean what kinda material is that?

Thanks for your wonderful videos. What's the name of block you use after sharpening the blade? I mean what kinda material is that?