In this video I bore the cylinder to final size and hone it. I also finish the exhaust mounting flange. I did not film some other parts of finishing but the cylinder is now basically ready for installing into the engine!
Пікірлер: 9
@Cristiantripodi4 жыл бұрын
Excelente!!
@sagres0preta3 жыл бұрын
did you make the cylinder yourself? is the cylinder cast iron? cool video
@ASoftaaja3 жыл бұрын
Yes, it's homemade and yes cast iron. You can see more of my videos about the making. Thanks!
@555aljaz2 жыл бұрын
After boring with a lathe how do you hone the cylinder what grits of stones do you use ? Do you do it all maunually or also on a lathe ?
@ASoftaaja2 жыл бұрын
I used a manual hone, a 4 stone adjustable unit from ebay. I think it was 120 grit first and finish with 320 grit. Using the hone by hand drill.
@Aabohax4 жыл бұрын
Pitkälle on tultu softaajan? Foorumin ajoista
@ASoftaaja4 жыл бұрын
On 😀
@jorgenelooliveira73512 жыл бұрын
Is stock cilynder am6 ? What size piston you use ?? 46mm?