DIY a square hole using a milling machine. I made a DIE SET for hydraulic press
Пікірлер: 11
@edsmachine9329 күн бұрын
Nice project. Nicely done. I just subscribed to your channel. Thanks for sharing. 👍
@JIMMY91629 күн бұрын
Thank you very much for your appreciation ! Your message means a lot to me.
@edsmachine9329 күн бұрын
@@JIMMY916 You're welcome Jimmy. Where are you from? I am from Northwest Arkansas. 👍
@JIMMY91629 күн бұрын
From very far...I'm from Europe
@iosifignat59724 ай бұрын
Cool!! Its nice to make your own tools, then use them do forge another tools hehe. Good luck my friend, i like it!
@axa.axa.4 ай бұрын
"HOW TO DRILL A SQUARE HOLE" ? did you mean how to make a punch die? didn't see any drilling....
@JIMMY9164 ай бұрын
My bad ! My description was wrong. I eliminated all the inaccuracies.. Thank you for your comment. It really helps 👍
@LetGaiaLive4 ай бұрын
No special tools, except the kiln, the lathe, tho collet set….. then I turned off the video at 2:50 timing point. I think I’ll make a coffee using nothing except my coffee grinder, coffee machine, milk frothed and microwave ‘coz I like my coffee nice & hot…… 🙄
@JIMMY9164 ай бұрын
There are special broches that produces such holes. I was referring to these special tools, which are very expensive. I'm sorry you thought they were made by witchcraft...🤔 Thank you for your comment !
@nathankrone33634 ай бұрын
What you're saying is it ain't easy. 😅
@JIMMY9164 ай бұрын
Thank you for your comment. If I had said that it's difficult, no one was watching...🤣