DIY CO2 Laser Cutter Build. Open Source GRBL ESP32/Arduino/DLC32
Рет қаралды 2,547
24 күн бұрынOpen Source CO2 Laser Cutter Build.
Timestamps
00:26 Intro
01:49 Cabinet
04:02 Gantry
11:31 Outer Frame
12:13 Electronics Panels
13:46 Ducting
14:23 Gantry Panels
15:54 Lid Install
16:23 Tube Install
16:46 Chiller Install
17:48 Wiring
18:33 Electronics Overview
19:30 Laser Head Install
19:56 Outside Frame Panels
20:22 First Steps
Specs:
Working Area: 600x400mm
Laser: 90 Watt SPT Laser Tube- C90
www.sptlaser.net/co2-laser-tu...
Power Supply: MYJG-100W
Extraction Fan: AC Infinity Cloudline S6 EC
Water Chiller: S&A CW-5200TH
Controller: Makerbase DLC32
github.com/makerbase-mks/MKS-...
Firmware: GRBL ESP32
github.com/bdring/Grbl_Esp32
Software: Lightburn
lightburnsoftware.com/
Project Repo:
github.com/kpatel122/Sparks-L...
(All links are non-affiliate)
DISCLAIMER: CO2 lasers and their electronics are dangerous. This information is provided for educational purposes only, use at your own risk- be safe.
@jondoe5866 20 күн бұрын
I love your take on the laser cutter. You did something new bold unique and different. I like how you shared wiring and light burn. I use the same board with fluid NC. You may want to store everything on an sd card. A few times I just powered off everything and the config file get lost. On my mac I like lightburn for modeling and designing. For quick cuts i like laser grbl its simple and easy to connect.
@kpmaking9647 20 күн бұрын
Thank you very much! And thanks for the heads up regarding the config. I export the lightburn settings and store them on the git repo just in case I need to install on a different machine I didn't know that the settings could be lost that way. Yeah lightburn is great, I'll have a look into grbl laser too. Cheers
@TOMA238 Күн бұрын
Can u show engaraving at high speed (400-500mm/s). I had a lot of problems whit that controler when engraving.
@kpmaking9647 9 сағат бұрын
I engrave at 250mm/s @20% power- No issues at that speed. But you have to consider the acceleration values to compare our speeds directly. Cheers
@adrienneowen1202 10 күн бұрын
do you have a parts list / instructions?
@kpmaking9647 6 күн бұрын
Not at the moment unfortunately all the info I have is on the repo for the project (which has the CAD, wiring and firmware). I may add this later.
FISPECKT
Рет қаралды 193 М.
Immersed
Рет қаралды 75 МЛН
Reboort_uzb
Рет қаралды 797 М.