Would've helped if you showed the other side of the table.
@jeremyarnold296811 ай бұрын
Nice man. Would love to do this myself.
@kodyneu48457 ай бұрын
Thank you for making this video very helpful and inspiring! I have a few questions…what diameter are the holes used to make the top, if not could they be made 3/4 and still create the right suction? How often do you have to clean the filters.
@josephAbenhaim Жыл бұрын
Did you order the top from sandpro or is that custom made too ? if so what material did you use for the redish grippy part ?
@josephbontrager2504 Жыл бұрын
I ordered the top from sand pro. It was like $250 I think.
@josephAbenhaim Жыл бұрын
@@josephbontrager2504 awesome thanks, do you have dimensions for your table ?
@Cpedro1685 Жыл бұрын
Very nice. What size fan is it?
@josephbontrager2504 Жыл бұрын
I’m not sure how you size them other then they don’t use cfm’s it’s what ever they use to measure vacuum. I got one that was the same physical size as the one on the sand pro. Sorry I know that’s not helpful.
@Cpedro1685 Жыл бұрын
@@josephbontrager2504 I here you. Thanks for the video!
@angelramos80903 ай бұрын
How do you clean it out? Where does the dust go?
@josephbontrager25043 ай бұрын
About half way through I open the lid and you can see filters in there. Those filters catch everything, you empty them by blowing them out.
@judahtate61988 ай бұрын
Where did you buy the fan/blower?
@josephbontrager25048 ай бұрын
It was from an old furnace I believe.
@HitRunTX5 ай бұрын
Does the fan exhaust out the bottom?
@josephbontrager25045 ай бұрын
Yes.
@thomascorser537 Жыл бұрын
Can I buy your plans for this table?
@josephbontrager2504 Жыл бұрын
it would be easier for mr to make video. ill try to do that.