Man this video helped me so much.really appreciate it. Before this video I was stuck trying to force out the entire control panel, unhooking the control cables is what did the trick. Whew!

Nice

Thanks!! I needed to know how to remove/install the manual wires! The technician didn't put them back and claims he "didn't touch the wiring" 😑

Thanks bud and grateful it's hot us or Canadian model so we evetthing is on the same side lol. No offence to all the guys that have great videos using North America bk mazdas your help has been invaluable, think I'm just a little.... Silly when it comes to following things on the reverse side 😂

Your car is very clean in there . When I removed my plastics, it was all dusty .

Thank you

Ps even though seems like a lot to take out these cars are new enough that evetthing comes out easily just like a jigsaw puzzle but it's knowing the order and any clip positions that will help you not break expensive plastics 😉

U mnie jedna z tych blaszek od drutu temperatury nawiewu jest założona pod tym białym plastikiem pod spodem panelu. Nie da się przez to tego wymienić bo nie widać czy udało się szczypcami złapać blaszkę

Thanks a lot.

What type of bulb is it?

Lots of work for a tiny bulb.. having this issue right now.. 😐

Thanks so much for this! It really helped!

Hey mate just wondering what model is the bulb and where did you purchase it? Thanks

Thanks so much

What type of bulb does it use and is it possible to remoce the orange accent on the knobs

hi, subscriber here in philippines, just want to know if it easy to find a job there in croatia for a filipina like me? my boyfriend is from koprivnica 😊 God Bless your family 🤗

Do these lights have a fuse?

Legendo, koja sijalica ide tu ?

How many bulbs needed replacing? Just the one? And part number?

what a not so maintenence friendly construction ...

Any one install LED's ? Good / Bad experience ?

Ok im not a fan or my auto climate control unit all digital and and works on a system where the temp control must get a pulse every time, the brushes or contacts come unto into contact with the points on the pcb board it self and sometimes they wear out of just fall off. Think of some old stereos from the 90s or even early 2000s that had volume controls that weren't actual proper resistive pots and they turned infinitely but if they got dirt or bad contacts they would act heywire and go up instead of down and vice versa lol idiot design just my personal opinion but someone has done a video of how to fix that it's as detailed or even more than this, might even be this guys video too I can't remember, but my lights are fine for now but the heat control takes so many turns to go up or down even worse when it's cold once warm it's pretty normal so hoping it's just dirt and not dry solder joints cos I would not enjoy that even though I can solder but I tiny things not so well. I'd love to do everything in my car blue lights think these sort of globes just use little condom looking socks that change the colour sometimes but that means doing the cluster and even the key barrel and electric window lights and that could be super tedious 😂 thanks for for very detailed video. Fantastic. And I hate my digital controls but I hate cable controls even more they never seem to go back the same for me lol. Although they probably are better as my vents don't seal properly either like the actuator doesn't move far enough in whatever direction it needs to to stop things coming through other events like it does but not completely so for instance I have it on just my feet or footwell it will still come out the main dash vents and the defog vent super annoying as I hate hot air in my face but love it on my feet 😂😂 ok enough rambling take care all. 😊