DIY Repair: Ryobi Electric Pressure Washer Fix!

No video

DIY Repair: Ryobi Electric Pressure Washer Fix!

Рет қаралды 7,344

Garming - Grow it, fix it, build it.

Күн бұрын

This is how I fixed a 2300psi 1.2gpm Ryobi electric pressure washer that would turn on but would not build any pressure what so ever. These are the steps I took to fix the unit and get it up and running again.

Пікірлер: 22

@edwardk99 11 күн бұрын

Your suggestion worked, thank you!!!!!! Who knew CLR could fix it?! So good, thank you again!!

@markellis3887 Ай бұрын

Thank You!!! I have same model -- just tried your recommendation and it works. For others: don't give up... I had to add more CLR to the soap dispenser and continue to run the washer. After about 3 to 5 minutes, it started spitting and eventually back to the strong power wash.

@yuyuzhao96 Ай бұрын

Will try your method again. P.S. I just add it in the water garden hose port (water go in) and seal the other side with balloon, and let it sit overnight, and it did not work.

@lifehappens168 2 ай бұрын

Doing this tomorrow!!! I hope it works! I already cut off the GFCI plug and it’s blowing breakers when it plugged in.

@andrearobach5923 2 ай бұрын

@lifehappens168 did you find a fix for this issue? Having same problem. Blowing breaker and neither the gfci cord or gfci outlet are set off.

@StKnightis64 2 ай бұрын

Thanks for posting.

@Liedaho Ай бұрын

This worked after I gave the pump a couple of light taps with a small dead blow. Left the CLR in overnight.

@yuyuzhao96 Ай бұрын

what do you mean dead blow? Thanks

@Liedaho Ай бұрын

@@yuyuzhao96A dead blow hammer. It has a soft face.

@jonevans09 2 ай бұрын

Will try this I have the same issue with the same model

@GarmingGFB 2 ай бұрын

good luck.

@danteespero8359 2 ай бұрын

Nice.

@HVACENGINEER94 Ай бұрын

I’m looking at one now for a friend, same symptom Wondering if I should pull the pump and check the springs and check valves I took one apart years ago and vaguely recall small springs and nylon discs/ plungers They may all be oxidized with hard water and siezed up CLR is worth a try along with 60 # h2o # behind it later on

@GarmingGFB Ай бұрын

for sure worth a shot.

@sovitbista1770 Ай бұрын

I have the same problem on the same model and I worked the same way , but didn’t solve my problem and still has no pressure . Is there any other solution?

@GarmingGFB Ай бұрын

pump internals might be bad. other than taking it apart not much. probably just need a new one. most stuff is junk now and disposable sadly.