No video
DIY Sign Post Build (Realtor/Address/mailbox)
Рет қаралды 6,322
Күн бұрынThis week I build a sign post with reclaimed pressure treated lumber for our new farm sign. I use a traditional half lap joint with mitered ends to make a simple but effective look. Finish it off with clearing out a patch by the front driveway, digging out a hole and installing it. Thanks for watching and please help support by following my channel. Thanks again!
@nolongermaestra 3 ай бұрын
Beautiful job and so well done for durability. Certainly like this video.
@caamnasty Жыл бұрын
Simple design, with limitless opportunity for variation -- like height, color, ornamentation. I'll be building mine following your methods.
@rebelde84 10 ай бұрын
it will pain in the butt to install and take off for sure.. nice work though!
@zuiking4915 9 ай бұрын
what is the angle at which you cut the top of the post, if you can share, it would be great, I'm about to make my real estate post for my first listing and I'm a DIYer, so... I'm gonna same some $ doing it 😅 thanks!
@landbalance 4 ай бұрын
That would look great for that. Might not want to use concrete lol It’s been a while…but I remember trying out a few angles on a test post just to see what looked better. I would start with a 45 first
@johnleeway7782 5 ай бұрын
How's come you sanded it AND THEN ran it through the planer? C'mon now son!
@landbalance 5 ай бұрын
Valid question. I should have shown a closeup. These were OLD posts that were covered with gravel dust and dirt from the driveway and when they were stored on the ground. I just ran a 60grit pad over it real quick to clean it off faster.
@johnleeway7782 5 ай бұрын
@@landbalance Makes sense. I was just given ya a hard time. Thanks for the reply!
@jerex112 3 ай бұрын
405 lol move your blur up a bit
@jerex112 3 ай бұрын
nice sign
Jon Peters - Longview Woodworking
Рет қаралды 148 М.
Sergio Outdoors
Рет қаралды 52 МЛН
CREATIVE COUPLE
Рет қаралды 63 МЛН