Where can I find these parts? Like a replacement yaw motor?

I have a problem with my Mavic 2 Zoom, some jitter on yaw axis appear from time to time(no error message for the motor though). You say something about some bad batch of yaw motors... Could this be the cause în my case? I bought the drone S-H, the seller swored it did not crash it, there were no signs but I couldn't see the problem with the yaw motor then but when it was too late to return it. The gimbal is mechanically fine, end points are ok, no springiness, no bendings...I now have to decide between buying a complete gimbal or just the yaw motor. Any idea, please?

Hello, great video. My mavic 2 had a fairly gentle crash into a bush and now won’t keep a level horizon. Everything works fine apart from that, I manually correct it in app but it will slowly tilt again and the auto calibrate function gets stuck at 20%. I’ve kind of accepted it now as I can correct in post but it’s annoying. Got told I needed an entire new gimbal/camera assembly for £580!

Thanks for the video i have the yaw motor issue. I wonder if dji fixes it for free

So how to calibrate the drone?

Hi Timothy, I have a mavic 2 pro gimbal that gives me motor overload error and camera is tilting down looks like a pitch motor is limp. How much would be to repair the gimbal?

Is there a difference between the Mavic 2 Pro and the Mavic 2 Zoom replacement part?

Hi, I falow your video and I replace my yaw and roll motor. Before I have only when I fly sideways a vibration from gimbal, not it says gimbal motor overloaded, and remain stuck at 60% calibration. I think I should replace the cable too? Need some advice please. What should I do next. Thanks for the help in advance

Hi, I ran into an issue with 3 different complete gimbals, one pro and two zoom for me, where gimbals go limp after motor start up. Gimbal will make weird buzzing noise and go limp, sometimes it will take few seconds and it goes limp. Most of the time in all 3 axis. All the ribbons are good. It started happening after few firmware upgrades. I have two M2, one pro and one zoom. It happens on both drones. I tried swapping the gimbals between the drones and the same thing. The worst thing is that there are no error messages after gimbal goes limp. Any suggestions or possible fixes ? What are the chances of getting a faulty new gimbal motors if so many were faulty from the factory ? Thank you for the time.

Is there anything else that would cause the camera to have that spring effect? I never crashed the drone that would have bent the control arm. I get the motor overload during flight for no real reason and the camera goes erratic.

What program do you use to calibrate on the computer?

Wow.. not so easy mine spuratically tilt camera mid flight first time i thought it was falling out of the sky smh could that same piece be whats bad.. and it hesitates to look up and down too

where can I get these parts ASAP? seems like only eBay from China

How are you doing Tim, I've been emailing you.....

Me pasa lo mismo con mi mavic 2 zoom el gimbal queda efocado hacia un lateral, como lo corrijo?

hi there i made a video that fixed my problem short term you should check it out . but i now want to fix it properly do you need special software for recalibration ?

Thanks for the video. My drone has a problem with the horizon. As the altitude increases, the horizon becomes slanted. I have a video of it here 6gTjPYdv9RM What is the reason for this, what is the cause?