Dump Truck Hydraulic Pump Dissasembling and Cleaning || Hydraulic Pump Repairing in Local Workshop #hydraulicpumprepairing #restoration #hydraulicpumpcleaning
Пікірлер: 19
@user-vb6uo5rj1q2 жыл бұрын
they don’t fix anything just only cleaning /assemble
@RanjanChathuranga.7 ай бұрын
very nice tool maintaining...
@MichaelArtischev2 жыл бұрын
больно смотреть как по подшипнику молотком лупят как умудряются при работе коллективом ничего не потерять и не перепутать - удивительно а вообще красавцы, конечно ещё и выглядят сравнительно опрятно при такой работе - я сам ремень генератора подтяну и весь в мазуте уважаю этим парням ещё бы инструмент хороший и расходники соответствующие!
@chapu27152 жыл бұрын
iiooop00ppp0...
@chapu27152 жыл бұрын
.
@MsCrush3r2 жыл бұрын
Разобрали, помыли, собрали. А вал со стесаными шлицами в хлам оставили.. Все что нужно знать о ремонте в Пакистане
@skillsvision47982 жыл бұрын
Very Nice
@francisdsa67902 жыл бұрын
Ustadgi àur do shagird bade kamke jugad karke Kam chalath hain👍👍👍👌👌👌🙏🙏🙏
@pietstemmet3763 Жыл бұрын
He should put the pump in vice
@karlbraun95643 жыл бұрын
I cringe every time I see them hit a bearing with a hammer. ⚒
@francescobobbo58983 жыл бұрын
They opened it, cleaned it, and then closed: idk what they meant to achieve. No bearings/seals changed, hammering almost everything, putting inside even more dust by "cleaning" it. Pure clickbaiting
@bigsmoke61892 жыл бұрын
@@francescobobbo5898 those OMFB piston pumps have check valves for each piston,if any dirt stops one seating the pump will be well down on pressure and flow so a clean could help.
@blocknyckeln2 жыл бұрын
i agree and not only that they always hammer on the outer ballbearing ring, wich hurts the ballbearings even more. they need to learn to hit it on the inner ballbearing ring
@ricardorodriguez52332 жыл бұрын
que buenos videos aprendo mas en sus videos que los de los americanos ellos usan todo nuevo desechan todo y uds las reparan felicidades
@margarita84422 жыл бұрын
they reuse the hydraulic fluid and add some dirt to improve viscosity !!
@harshabiliangady32112 жыл бұрын
One boy is so young that he should be in school.
@hendarnovi91082 жыл бұрын
Banyak amat tangan nya
@bigsmoke61892 жыл бұрын
I'm wondering why the pressure outlet fitting has an extra outlet welded on the side since it's only supplying oil to the tipping control valve and cylinder .
@louisd1002 жыл бұрын
This stuff is always so dodgy. I get they don't have proper workshops and all the correct parts etc. But still.