Let me explain!
This IFP depth of 6.5 cm is taken from the net and is in line with reality, so I am giving it here because it is completely easier to set. I admit that I personally put the spells in the form of 31mm on the pressed shaft (I held it with my knee from the bottom and tightened the topcap from above). Overall, it should be as shallow as possible, as long as there is no hry-blockade (i.e. a situation where the shaft does not go to the very end because the IFP piston has nowhere to move and then we do not have a full stroke). .
Write how you do it, I am curious how others come to such information. First, I imagine how it works, I try to measure it, and then I test it using experience and a little sense. You don't always hit the first try, but if you understand the principle of operation, you at least know what to improve.
0:00 Introduction
0:25 Disassemble
3:32 Full service of RC2 damper (disassembly)
7:26 Full service of RC2 damper (assembly)
14:54 Assembling durolux
21:39 Exodus
22:00 A few words about this fork