Cycle Solutions's Chris Waddel demonstrates how to set the Throttle Position Sensor on your Dynojet Power Commander III or V to ensure your map is aligned properly.
Пікірлер: 22
@bigfhands3 жыл бұрын
fyi if you pin the throttle when tern the key but don’t start it will flash the 100% throttle voltage that you need to input into that field just make shore you have that calibration window visible so you can see remember and then enter the voltage value in the same window
@doubless17178 жыл бұрын
thank you! simple and to the point.
@paul1e6 жыл бұрын
Do you have to touch the thorttle or just that slider and rear break ?
@toppocbr5 жыл бұрын
hi ive got a pc3 on a 650f Suzuki the maps that I find are for the pc5 how to I get that maps to work with the pc3
@goodboyringo97164 жыл бұрын
Can I do that without a dyno ?
@joserodolfoignacioperalta46873 жыл бұрын
Hello brother, I have a suzuki gsxr 1000 2009 and I am urging the pawer comander 5 of dino jet and I do not get rpm reading to put tuniar? , what could you be. I would appreciate your help. thanks
@jeanmarcPrizzon4 жыл бұрын
Stop the music... Please ! ! !
@kenstirling53483 жыл бұрын
Looks like they’re on a Mobil dyno at a bike show and that music is part of the event that they can’t control
@jeepcj7dude10 жыл бұрын
you cant do the 100% with the ignition on but the bike not running?
@BoobsAdmin2 жыл бұрын
Without starting the bike, there is a voltage drop directly from the battery, so you need to adjust only on running motorcycle!
@alixvandurand Жыл бұрын
@@BoobsAdmin So I was data logging using the POD300 and realized my throttle position was doing weird stuff, like when I was riding around and I put on a percentage of throttle above say 40% and held it there, I noticed the TPS would register the initial value then suddenly start falling until it was at least 15% or even up to 50% below where I actually was! I always calibrated my throttle with the bike off.... I'm beginning to suspect this is why. Weirdly though, if I put to 100%, it will stay 100%. If I go to 99%, it will fall to 70 or whatever almost right away until I move my wrist again.
@BoobsAdmin Жыл бұрын
@@alixvandurand Moreover, the motor must be fully warmed up. This is indicated in the official instructions. ✅
@alixvandurand Жыл бұрын
@@BoobsAdmin I never read them xD I don't think they're included with the device cause I usually read what comes with stuff. Thanks for letting me know! Will recalibrate tomorrow!
@Antmanmoto4 жыл бұрын
That wasn’t confusing
@maiktajda2 жыл бұрын
If you lowering the volume of music i can hear you better. 🙏🏻🙏🏻🙏🏻🤯🤯🤕🤕
@fingerscrossed23176 жыл бұрын
I think I let this part over to the specialist, my old cb 650 I rather do myself, that's a long other story.
@kenstirling53483 жыл бұрын
If I don’t have a dyno can I just rev my shit in neutral?