Thank you for this great vid. I have exactly the same style of lamp on my 1994 E36 and your video is the only one I found that shows the "rubber" ring around the actual inner glass as mine is AND how to remove as I was concerned about breaking the glass! I have had years of damp in the headlamp unit, been to garages who apparently just heated and cleared until the next rainfall! Well done on this and subbed!
@twizzy8783 Жыл бұрын
idk much about e36's but i'd say that upgrade was totally worth it! The projectors look much cleaner
@Braymond141 Жыл бұрын
Nice job, Tommy! Good pick going with Bosch too. They are the better of the Euro light options (IMO). Thanks for your purchase on the PnP adapters. If you need a set of static rods to replace the electric adjusters, please reach out. It will clean up the install a bit more and also allow you to install a cold air intake on the driver side (if you planned on something like Dinan). Can I link your install video on my website?
@spec_egg Жыл бұрын
Hi, thank you for the comment! I’m a fan of all the parts you make for the E36! I have also installed the brackets/reinforcement as well as the cover for the Dinan strut bar on my car. They’re all great products! I’ll reach out if I ever need the static rod! Yes please feel free to link the install video on your website! 😁
@MartelMartin736 Жыл бұрын
I saw your fog lamps turn off when your bright was on, what's the setup on that?
@spec_egg Жыл бұрын
I think that’s actually just how it is from the factory.
@MartelMartin736 Жыл бұрын
@@spec_egg okay cause mine is the same but when I turn on the park light the flasher doesn't turn on
@MartelMartin736 Жыл бұрын
@@spec_egg and I should have said I have a button on mine that turns the fog lamps on and off
@brianantoine31038 ай бұрын
Just asking, is it possible to separate the glass reflector from the frame? The grooves for the indicators to slide into broke on mine @3:23 and i want to replace that frame but not necessarily the glass
@spec_egg8 ай бұрын
I’m not 100% sure but I do think the frame and the reflector are two separate pieces but it might be hard to source just the frame itself. Good luck!
@brianantoine31038 ай бұрын
@@spec_egg yea Im just looking for the frame because my inserts broke for the corner light. Im thinking of fabricating a piece for it because these prices for the lens with the frame are slightly high and the ones im seeing for cheap may not actually be compatible with the OEM glass