E46 Build Ep. 6 (Fuel Pump troubleshooting and replacement)

No video

E46 Build Ep. 6 (Fuel Pump troubleshooting and replacement)

Рет қаралды 13,756

Күн бұрын

Is your car acting sus and not starting? We got the vid for you! We troubleshoot our E46 and try a few simple troubleshooting techniques to diagnose a bad fuel pump.

Пікірлер: 27

@AsadKhan-lm6yr Жыл бұрын

Just changed mine. Bought the part from a guy breaking his car! Was reassured by the fact that your girlfriend could do it…so why not me?!! She’s a gem. Gotta say you guys are a lovely couple. Have yourselves a great life together!! ❤ Thanks again

@camerontruskett511 5 ай бұрын

It's good to see that you are actually teaching your girlfriend what to do in case something in future was to stuff up she will know what to do, ❤ love it keep on teaching her & she maybe able to show you a thing or two in the future, well done mate

@jesusulloa640 Жыл бұрын

My e46 just did the same thing today, feels like the fuel pump. Thanks for the video

@slightlymodified501 Жыл бұрын

Hope it helped!

@ater_leporidae5695 Жыл бұрын

@@slightlymodified501 exactly my problem also, hope it helps, will see. great video man keep it up

@AsadKhan-lm6yr Жыл бұрын

And thanks again for the video

@mhellcess4532 Ай бұрын

Nice video man do you have a link? Thanks

@lexiaontube Ай бұрын

Does it still run with the el cheapo pump ?

@AsadKhan-lm6yr Жыл бұрын

Hi. Do you have the link for the fuel pump you bought for an e46 M3 please?

@998RC 4 ай бұрын

Great video, but can you post a link to the fuel pump you got, and has it been fine since?

@bige673 Жыл бұрын

Where did you buy the fuelpump from

@998RC 2 ай бұрын

What does it mean if I see 4v at the pump before even putting the key into the ignition. Then 12v when turning it on for a couple seconds?

@alexluz7023 4 ай бұрын

i bet the code was for "fuel pump left the house"... when he tested the wiring unpluged and turned on acc (key on first position) looking for the 12v on the plug.. the ecu probably notice there was no pump.

@kristiansamaj3665 Жыл бұрын

Hello I have problem with my 320d fuse is good but it doesn't give electrics to the pump what it can be ? And pump is good I try the pumpu start with battery on + and - and it goes (Sorry for my bad English)

@supaxlvztr 5 ай бұрын

It’s that simple huh? My shop was trying to charge me something like $2,000 for the fuel pump and labor 🤦🏾‍♂️

@slightlymodified501 4 ай бұрын

200 is highway robbery for a fuel pump in this car

@geramane5184 Жыл бұрын

What was the code? For the engine light ?

@alexluz7023 4 ай бұрын

@excidi Жыл бұрын

My key points 2:00 2:40 5:22

@slightlymodified501 Жыл бұрын

Hope it helped 🤙🏻

@talbotd27 Жыл бұрын

Man I can’t get the dam pump to come out. Like every video I watch as soon as they have that collar off and the hose disconnected it just lifts right out. But I’m over here yanking in the thing watching the whole area around it lift up and the thing just will not come out

@slightlymodified501 Жыл бұрын

Clean off the area and try the use a flat head or a trim tool to break the seal. Its a tight fit it will come out

@talbotd27 Жыл бұрын

@@slightlymodified501 I actually just got it off, which is great but now my concern is that I saw a good amount of little dirt and whatnot had fallen down into the tank. I’m a little concerned about starting the car without trying to get that dirt/debris out of there

@slightlymodified501 Жыл бұрын

@@talbotd27 replace your fuel filter too. Shouldn’t be too bad

@talbotd27 Жыл бұрын

@@slightlymodified501 alright, will do. Thanks for your help, nobody else was awake right now and I really wanted to get the job done tonight

@yaghiyahbrenner8902 7 ай бұрын

don't ever do what this guy does "rub fuel on the rubber gasket" its stupid! you need to use grease. fuel will dry out the rubber and crack the seal.

@slightlymodified501 7 ай бұрын

I get what you are saying. But in this case the rubber is fuel resistant. Same with injector O-rings. Any o-ring that touches fuel needs to be Viton or Nitrile.