Solving a no-spark issue on the CT70 engine

Рет қаралды 20,292

2 жыл бұрын

It took me hours to run down a problem that was preventing me from getting spark on my 1971 CT70 project. Turns out it was simple, but thought I'd make a quick video highlighting some common problems.

Пікірлер: 22

@vwfreshness459 2 жыл бұрын

I had something very similar happen, my wire between the points and condenser was touching the case of the condenser. I now use heat shrink on any wire that can come close to grounding out. Awesome video

@thomaspencak5811 2 жыл бұрын

I believe you helped me out with this video. Ignition problems will drive a sane man crazy! I would like to add that even if they are not touching but close on the secondary, a spark can jump and reduce the output so the spark voltage is lower, but not enough to jump across.

@nicksandeno7672 Жыл бұрын

This is great camera work and really helpful! Thanks for a quality video!

@melfrank8379 7 ай бұрын

The lead that comes off the points and goes to the ignition coil, is how I always set my point gap as a kid, I connected an ohm meter, or test light with a battery in circuit from the ground of the motor to that lead and turned the flywheel slowly till the timing marks lined up. The meter showed a reading of continuity to ground or the light would stay on until the moment the points were opened, I would set the points so they opened right when the timing marks lined up. The proper tools and troubleshooting skills with electrical circuits makes these kind of problems very easy to diagnose.

@kellyleewright97 Жыл бұрын

Nice job sir! Great video.

@toddpetersen2251 10 ай бұрын

Thank you for this video I just bought my first a t c last night gotta home after work today to figure out what I needed to do I have no fire. Now I have a better idea of what i'm getting into tomorrow really appreciate it.

@eastcoastish 9 ай бұрын

Good luck!

@frankrichins369 Жыл бұрын

Thank you. Very helpful video. Much appreciated 👍

@doglegjake6788 6 ай бұрын

Excellent video

@garrettschlegel5653 Жыл бұрын

Great explanation

@mikeatv Жыл бұрын

great video helped me alot

@mmetz1877 10 ай бұрын

Thanks for the tips!

@markstevens8970 2 жыл бұрын

Very helpful many thanks 😊

@NizeDirt Жыл бұрын

THANK YOU SOOOO MUCH, THIS IS EXAVTLY WHAT WAS HAPPENING TO MINE!!!!!

@vernprescott7084 7 ай бұрын

Great video man. Where did you get the engine stand?

@jeanjacquesfortiable 2 ай бұрын

hi I see that you use your impact to run your engine but what type of socket do you use? bye good video !

@dennisdougherty1432 5 ай бұрын

Thanks for that Video. Any idea what the ac voltage output should be on a 1986 xr100. ??? I am reading with a test light and get a nice bright flicker. When I test the ac voltage from the charging coil it is reading between 5.5vac and 7.3vac with a drill turning the engine. Thanks