This video turned out to be much more helpful than I thought it would at the start! 🤣Great descriptions! Great camera work! Minimal banter!

Nice video guys. Great camera work and very thorough info . 👍

Just finished the job and i can confirm that did, infact, have a bad day

Just changed my starter, worked perfectly. Thanks guys! I would note that the wire aspect of it is likely the most annoying part. I had to bend the wire a little bit to actually get it to fit on properly again. It took me an hour just to work that part out. Otherwise the change is not super difficult. Make sure you guys fit the bottom bolt on first and then the top to make sure the starter is in place properly -- if the fitting is off, the wire bit won't get on properly.

Your video was great. Do more. It's like explaining mechanic work for the less mechanical inclined, made me another less nervous to doing it

Great video guys, please make more about this vehicle.

Other videos show taking the manifold off, I wonder if this way is better, great video guys, got a new subscriber here

Great video. That car needs a VCM disable device though.

Excellent description and video

Thank you for sharing, I need to do this soon.

Thanks guys. You guys have great personality and your video is very clear. I might have to replace my starter as well. Still troubleshooting to is if it's the battery, or relay/fuse/ignition switch. But i know it will be very useful instructions you gave in this video both in technical and safety aspects.

bout to go do it

What's the bolt torque spec on the starter?

Did you have any problems using the old shim or was the problem fixed?

I used a 12mm instead of the 13mm that you recommended for that top-nut, 13 didn't work, too loose. Also used 14mm instead of the 15mm you recommended for the 2 screws, same thing. Just wondering. Would have been nice for a link to PARTS.

The reason the negative cable I'd removed first is to prevent accidentally touching ground when removing the positive first.

Where u buy starter ??

lucky i live on a hill & have a `el manual...lol, not really hey fyi~ either your ghosted(I`m ghost busting...LOL) in comments or you deleted comment? i can see it in notifications but i cant reply to it or find it anywhere ? "Peace, Love and Guns commented: "Does the 1911 jam? lololololol 🤣 I crack myself up. Seriously though. I do like the AK47. I personally carry the Talwar by them, which is a BIG honkin folder that you can choke back on like the..." 10 hours ago" You could get a Glock knife, it wont jam, its hi quality for 'cheap' & made in Austria! The Talwar is badass, i think they will make it again soon! Where was original Talwar manufactured? I would love to see more USA made CS! I been caring the CS Frenzy for a minute, one of the best larger knives for EDC, its slim & 'light'! i want a CS Colossus & one of there new 'plastic'(FGX) balisong`s for fun & a possible shower knife! When your in the shower & the Psycho music starts to play, mother should be worried for her little boy! LOL

Replacing the starter may not fix the grinding. Honda released a TSB 16-002 where the torque converter needs to be rotated to allow proper alignment of the sprocket. The video is very helpful though, it is better that there was a camera-man while you were working.