Hello, Is it possible to mount a DRO on a lathe (Grizzly G4003G) that has the taper attachment without interfering with each other? Thanks. Doug

Hi folks, if watching this four part series please note that comments have been turned off on part four. I'm not surprised, there is a very bad mistake. The presenter quite correctly talks about about making sure there are no electronics behind any panel you are thinking of drilling into and is then shown drilling in with the panel in place. The drill will break through and destroy the very expensive control board that has just been shown to be behind the panel. What were they thinking! In my opinion a more customer caring approach would have been to re-shoot or at least re-edit the video. BobUK.