This is the best video I've seen on embossing folders. Thank you, Brenda! I learned a lot!

You answered my question perfectly! Thank you so much

nuts, sizzix 3-D folder and the big kick/shot was what i was looking for, but after trying a couple times found , four to five sheets of card stock along with tab 1 and a plate sorta did it.

Brenda, Thank you for this demonstration. You answered my question, and I learned so much more. What a blessing . Thanks, again.

I appreciate that you made this video. I have a Big Shot and the Stampin' Up 3D plate. I tried it the way you showed, and it wouldn't go through. So, I wondered if I used it on tab one, if it might work. I'm glad I watched the video to the end, as you actually mentioned doing so, as a remedy for that. Thank you so much!

Brenda - You just said that with directional embossing folders, we may have to run them through the cutter open end first, not fold first. I thought that would crack the fold.

Hi, I enjoyed your video, now a Question? I have a lot of used embossing folders that do not have the paper line printed across the bottom of them, can you measure how far up the line is from the edge of the folder and provide the measurement? Do you think that I could just mark this line with a permanent marker on the used folders to create the same effect? Just looking at the video it looks to be about a 1-inch mark. Hope that makes sense?