Engine Knocking Noise Diagnosing.
Рет қаралды 851
2 ай бұрынthis vehicle came to our garage with the loud knocking noise coming from the engine, after investigation we diagnosed the engine knocking noise and recorded this diagnosing procedure and uploaded here to our channel, if your car has the same symptoms this may help you diagnose your vehicle.
Disclaimer:
this video only contains tips and recommendations that could be useful when carrying out vehicle repairs or replacement parts, STANHOPE AUTO REPAIR CENTRE WARDAK is not liable for any damage, harm injury or property damage incurred while carrying out repairs or replacement that are a result of incorrect use or misinterpretation of the provided information purposes only and does not guarantee achievement of specific result. The user is personally liable for incorrect use of repair equipment, tools or vehicle parts, in particular, when this use poses the risk of injury. STANHOPE AUTO REPAIR CENTRE WARDAK strongly recommends being careful and adhering to the safety rules when doing any repair or replace.
@tonymontana897 2 ай бұрын
It is unusual for just one rod bearing to fail. If there was an oiling issue then all the bearings would exhibit the same amount of wear. You think this could be a factory clearance issue ? 151K miles on the engine isn't that much. Are you going to rebuild the bottom end or is this engine finished ?
@stanhopeautorepaircentrewardak 2 ай бұрын
Thanks for watching our channel. The customer chose to replace the engine with another used one instead of repairing this one.
@allen5976 2 ай бұрын
Using a thermometer for diagnostic of tapping noise😩
@stanhopeautorepaircentrewardak 2 ай бұрын
Using the thermometer to show you the engine temperature, to understand, at what temperature of the engine you are permitted to check the engine oil pressure, i don't know how sensible you are that you can't distinguish the bottom end noise with the top end noise, do you think the tappets noise is that much louder and it occurs after long pause in between. I have clearly shown that the cylinder No. 3 big end bearing shells have gone, and you didn't see the big end bearing play, or you did it?
@sampsonsunny6298 2 ай бұрын
Tappet loose, lifter no good.
@stanhopeautorepaircentrewardak 2 ай бұрын
No. 3 big end (connecting rod bearin shells have gone).
@sampsonsunny6298 2 ай бұрын
Diesel engine? No.
@stanhopeautorepaircentrewardak 2 ай бұрын
Yes, 1.9DTI BLS engine
Garage 54
Рет қаралды 4,1 МЛН
driving 4 answers
Рет қаралды 78 М.
Budget Mechanic
Рет қаралды 277 М.
Мотомалышка Алина
Рет қаралды 2,5 МЛН
vazovskie.official
Рет қаралды 1,5 МЛН