Рет қаралды 16,817
In this video I install the VIBS board for version 2 in the correct manner that will not fry your board or monitors. This will allow the backglass to display like a traditional pinball machine in OTG mode connected to a gaming PC.
I also tackle and solve the Steam FX3 backglass and DMD parameters for those that tried WagnersTechTalk like me and it didn’t work for them. Big thank you to Wagner for the helpful information on everything else!
Like and subscribe, thank you!
wagnerstechtalk...
AMD Ryzen 5 5600X
16GB
NVIDIA GeForce RTX 3060
12GB GDDR6
VIBS Board
2 HDMI Cords needed
1 Male to Male USB 2.0 3-6ft no longer
Under no circumstances will John Paul’s Garagecade be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether through John Paul’s Garagecade KZfaq Channel or a third party, in no event shall JPG be liable for any special, indirect or consequential factors beyond the control of JPG. JPG cannot guarantee against improper use or unauthorized modifications of this information. John Paul’s Garagecade assumes no liability for property damage or injury incurred as a result of any of the information contained in this video, Use this information at your own risk. JPG recommends safe practices when performing any do it yourself repairs and of with tools seen or implied in this video. Due to factors beyond the control of JPG, no information contained in this video shall create any expressed of implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment or information contained in this video is the sole responsibility of the user and not John Paul’s Garagecade.