I feel your pain. I got a “free “ 96’ fourtrax 300 that had been sitting outside uncovered for years. Should have known better.🙄 I had to friggin break my brake hub into pieces with a hammer then had to cut through what was left of the hub with a saws all and an air cutoff tool. Then I had to slowly drive the hub off with an air chisel. I tried to drive the whole axle through from the right side like the guy on this video, but it wouldn’t budge so I said forget it. Luckily my bearings appeared to be ok. Better to stop before I break something. It’s been an ordeal.

Ha! Never thought of that heating trick for the pinion bearing. Nice

Can’t wait for preseason sled videos!

I'm about to tackle this project on my 85 big red wish me luck

I did that same job this summer

Nice vid. All the info helps in case I have to end up doing this..... hope not...but eh..you never know. Thanks!!!

Lol I wish it was that easy getting that bearing out😂

Does the axel come out either way or just beat it to the right?

What size wrench for the rear double axle nuts

I have a 1993 honda fourtrax i need to de rear end work there is a tick in rearend when i am on throttle only? And my big gear in rear end pinion? I think anyways its got chunks missing i have used it for plowing last 3years plus run it alot lol great machines my question is what should i guy order for parts

eesh! what a pain!

R u going to the show I need a new t shit .

What does that funky nut do???

Sweeeeeet

Did you build your own service lift. Looking for one.

What is the size or dimension exemple 2x2 or 4x4 ? of the Tubing (HSS) thx for your answer

What size socket

If that’s a shot diff then mine is just non existent

What size tool do i need to take the axle off

Are you going to expo sno?

WHAT SIZE ARE THE REAR AXLE NUTS?

Beautiful love u.