EQT RS3 Brushless Low Pressure Fuel Pump Install
Рет қаралды 12,163
2 жыл бұрынThe EQT Brushless Low Pressure Fuel Pump (LPFP) is a perfect upgrade for your EA888.3 powered vehicle and is available in both FWD and AWD configurations.
eqtuning.com/collections/vw-a...
This kit is a drop in pump that requires no modification to your original equipment. It includes everything necessary to drop into your tank and go.
This is a perfect solution for built engine and factory engine vehicles. There is no need for blending or worrying about your ethanol content when running this fuel pump as it has been proven up to 550whp on stock fuel lines with E85 and 600whp on upgraded lines. (Fuel Line kit coming soon)
Kit Contents:
Drop-In Brushless Fuel Pump
Black Brushless Fuel Pump Controller
Plug and Play Wiring Harness
@GTiz4Ever 2 жыл бұрын
Another great vid. Glad you covered the EQT tune upgrade for the install. I was wondering about that. Thanks so much.
@KrooksGaming Жыл бұрын
Used this guide to pull out the lpfp on my mk7 GTI to replace the suction pump. Thank you !!!!
@debrajohnson4689 Жыл бұрын
the best video by far i have seen for install!
@EVERYTHINGcpo Жыл бұрын
Thank you!
@razorraysolarsavings70 2 жыл бұрын
Great detailed video. Lol I feel confident I can do this after maybe watching the video a few more times. I like how you can do the LPFP and just upgrade the tune until you have either the MPI or HPFP installed and then install the upgraded turbo. EQT does it well and Vaarticus. ;)
@derrickzimny6015 2 жыл бұрын
Great video as always. Keep them coming
@spicygti6148 Жыл бұрын
Does the new fuse you added come with the pump?
@bigshot_blake98 2 жыл бұрын
SOOO. I can put this pump on my GTI. im assuming this has a built in fpcm
@One_Guy 10 ай бұрын
15:00 be careful with just slapping in a higher rated fuse.. while this will keep it from popping and let it draw more amps, are the wires capable of this added amperage? if you put too high of a fuse in you could burn the whole car to the ground.
@alexforbes2646 2 жыл бұрын
So quick question - this solution does NOT require something like the Torqbyte PM4 (separate controller) where doing your own like a Walboro or Deatschwerks would?
@EVERYTHINGcpo 2 жыл бұрын
Correct. It has its own controller.
@nismology 7 ай бұрын
If you're referring to the DW DW300C no controller upgrade is required. It stays under the 16A limit of the stock unit.
@Straight.Mata. 2 жыл бұрын
do you have to prime this pump? if so how? or what did you do before turning the car on any other steps?
@EVERYTHINGcpo 2 жыл бұрын
I just started the car. It took a few extra seconds the first time, but was good.
@Black-io1qg 10 ай бұрын
Can I run this on stock tune. I need to go back to stock tune for a little and wanted to know if I had to remove it and put in the old one
@EVERYTHINGcpo 10 ай бұрын
No. You need a tune to specifically account for the LPFP.
@diazandhisdaily801 2 жыл бұрын
Are you able to install the LPFP Pump and run it without a tune?
@EVERYTHINGcpo 2 жыл бұрын
No. It requires custom tuning.
@racer247 Жыл бұрын
Why is there so much gas left in the tank even though you drained it ?
@EVERYTHINGcpo Жыл бұрын
A because I didn’t drain it all the way. Only almost all they way. Fuel gauge close to E was fine for me. Really could do it with 1/4 tank if you wanted to.
@JordieG8 9 ай бұрын
There is really no need to run “full” E85. E40 will be more than enough to see the largest chunk of benefits of ethanol. Ethanol is often misrepresented as having a linear content vs benefit line and that’s just not the case. Once you’re able to hit MBT at a particular boost level the benefits have been realized and there is really no need to run more. You’re just going to burn it faster and amplify some of the draw backs of ethanol.
@ju-exhaust8316 6 ай бұрын
Hello I would like to buy only the electric motor for the pump EQT STANDARD BRUSHLESS LPFP - VW/AUDI MQB/E 1.8T/2.0T
@EVERYTHINGcpo 6 ай бұрын
I would contact EQT directly.
@ju-exhaust8316 6 ай бұрын
ok thanks@@EVERYTHINGcpo
@Lurchalicious 2 жыл бұрын
was your fuel gauge correct right from the start?
@EVERYTHINGcpo 2 жыл бұрын
Usually after I drain the tank I don’t consider the gauge to be accurate until my first full fill up
@Perceivedshift 2 жыл бұрын
Uhhggg you missed an important detail when removing the fuel line from the lpfp, PUSH DOWN and press the tab, then pull up slowly!
@HugeVictor 2 жыл бұрын
The price on this is absolutely insane and not in a good way.
@EVERYTHINGcpo 2 жыл бұрын
Not gonna try and justify their price, because I agree it’s way too expensive (everything is) but they are in line with the other brushless drop-in options. You can save some money with brushed pumps… but that’s taking a step in the wrong direction! :-)
@cmschmidt15 2 жыл бұрын
You can piece together your own RS3 brushless LPFP kit for $850 or so, they are just Audi parts you can order direct and then get the A2B RS3 DIY fuel pump harness for either AWD or FWD which comes with the necessary extra parts for adapting to the Mk7 platform. Part numbers for the RS3 pump is 8V0919087A, black fuel controller (module) is 4M0906093N, seal is 1J0919133B and metal nut on top of the tank is 1K0201375. The pump itself is the same for AWD or FWD, the extra bits is what makes it different between R/GTI and that comes from the A2B DIY kit. So you can figure out the quick math if you want to spend more for the turn-key package or save a few hundred to push in some plastic parts yourself.
@debrajohnson4689 2 жыл бұрын
example the fuel pump is only $441 on that site I hope everyone understands the markup on audi parts is insane just need to shop around but when it comes to fuel pumps and certain parts always buy new
@TheDsantander 2 жыл бұрын
Did your lungs survive?
Diego Arias
Рет қаралды 6 М.
EVERYTHING cpo (@Vaarticus; @go.fast.r)
Рет қаралды 19 М.
All Stars Motorsport
Рет қаралды 35 М.
German Elite Tuning
Рет қаралды 1,3 М.
EVERYTHING cpo (@Vaarticus; @go.fast.r)
Рет қаралды 10 М.