Thank you ! I just purchased a fardriver and I'm just waiting for the Bluetooth adapter, Great videos absolutely helpful in so many ways.

Im from indonesia, i like your videos, i can to self learn from your video Thank you sir good job 👍

Thank you for this info and the series. You are very knowledgeable on a vague subject. Thank you again 😊

Все четко обьяснил, дисплей отличный, жду продолжения! Спасибо )

Hello. Thank you very much for your videos, they are quite clear and explanatory. They have been very helpful to me. Regarding the display, do you sell it? or could you leave a purchase link?

Super helpful, thank you

Thanks for all your hard work.

Where did you buy this display? Its possible to set mph instead of kmph?

Very helpful, thank you

Podrias dejarme el enlace de compra del display?

Thank you. Great video. I am very much interested in Fardriver controller. Will the display settings and everything ODO etc persist after battery removal or not? Planning to change my ebike controller from Savboton to Fardriver but the display situation has alway put me off.

Hi , Can you please help me, my MTPA on the phone , shows Red and not green. please advice. thanks

I want to buy a 72360 with the display shown in the video. Where can I purchase it?

Can you maybe help me. I recently buy one motorbike when the battery lithium 72v 30 Ah is connected, it always shows as 100% full with four bars on the speed display. However, the issue is that the bars do not decrease while driving; it remains at 100%. When I travel around 50 kilometers , the battery runs out but I only get the low battery signal with the icon appearing just about 30 seconds to a minute before it's completely depleted. This means I never see the battery level drop; it's either full or empty, making it very difficult to manage the autonomy, knowing when to recharge, especially since it could run out when far from a charging point.

Which pin in the board of controller for single line digital speedometer? Because i can't found the light blue wire on the my controller. And the wiring colour is very different with your controller.

Can you also tell us more about the CAN control, Can you please tell me how we can connect this display with the BMS using the CAN Protocol, to check the available range? Thank you so much for this awesome video.

This must be why on the generic controllers I use lately with no display the 3 speed does not change motor speed. They are set to 0 at the factory. But I have older controllers that the 3 speed does work. Also the controller low voltage cut off on my 48/60/72 volt controller is set to 42 volts for a 48 v battery. I was using a 52v battery and the BMS must have no over discharge protection because it did not cut off till 42v. Not good.

Can I use induction motor to drive my rear wheels.

Alangkah baiknya ketika anda juga membuat video versi votol controller

Can you show circuit diagram for test board?

Thank for your effort. But I have a question. Can I use Power Supply 72V 10A to test with Far-Driver instead of using Battery.

My speed is not matching how do I calibrate it?

Hi bro How did you find the number of pole pairs, if we do not know the pole pair of the motor, how can we find out (without opening the motor)

hi, you're great, I always follow you. where can I buy this display?

Isn't there a tiny screen option aviable ? That thing is way to big

☆ HELP ☆ HELP ☆ why can I not connect to my 72450 FarDriver from the FarDriver app. Someone else is bound, guy says it won't let him connect to unbind. Please help

Will this work with a 5k watt motor?

I can only use this controller on this display. Or I can use another controller....?

how do you know to use the light blue wire from the controller to the screen?

Hello I have the same set up when i connect the battery to the controller im only reading 1.7v but the battery is reading 68.2v any ideas? Has the controller gone faulty??

Fardriver with pedal assist connection?

How to custom booting logo screen?

hello could you please tell us the model number for this display so i dont get it wrong when i order thank you very much

Hi I'm from France Would you consider zoom meetings so we can create an international ev enthusiasts group

Any link to that display ? is it a SIAECOSYS variant ?? none seem to show the multimedia option like yours.

Will this work woth bac8000

What kind of display is that?

where can you buy such a display?

Kalkarken neden zor kalkıyor, araç titriyor

top video

Salve mi sa dire gentilmente come si fa a capire se un display è compatibile con qualsiasi centralina? Grazie

Здравствуйте! Где такой дисплей можно купить. Есть ссылка?

What lcd panel is that. May I have link

stop jabber jawing and hit that chinese m365 motor with the 390a phase current that controller claims. 👍👌⚡💥🔥☠️

What display model?

Why are you avoiding everyone.?? put a link for the display..